International Concepts C-613 User manual

ITEM :
C
-
613
REVISED FEB 6, 2012
Printed in Vietnam
- 1 -
Description
Item No.
:
X
-
BACK CHAIR
: C-613
ASSEMBLY
INSTRUCTIONS

ITEM :
C
-
613
REVISED FEB 6, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for
durability. Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment.
Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call Toll Free: 1-888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being
scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Back 1 B Seat Frame 1
C Seat 1 D Front Leg
(L-R) 2
E Side Stretcher 2 F Front stretcher 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM :
C
-
613
REVISED FEB 6, 2012
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Short bolt
(M6x40mm)
3 2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6x80mm)
4 4
Screw
(M4x35mm)
10
5
Flat washer
(6.5x19mm)
11 6
Lock washer
(6.5x11mm)
11
7
Allen key
(4mm)
1
STEP 1
Attach seat frame (B) to the back (A) with bolts (1) and (3), and washers (5) and (6) ,tighten with Allen
key (7) as shown below.
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.

ITEM :
C
-
613
REVISED FEB 6, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach front legs (D) to the seat frame with bolts (2), washers (5) and (6) .Tighten with Allen key (7).
Attach front stretcher (F) between front legs and side stretchers (E) to front and back legs with screws
(4). Tighten with a screwdriver.
STEP 3
Attach the seat (C) to top of the seat frame (from Step 2) with screws (4). Tighten with the screw
driver.