International Concepts OT-92 User manual

ITEM NO.: OT-92
REVISED NOV 05, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item
:LAMPTABLE
: OT-92

ITEM NO.: OT-92
REVISED NOV 05, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
product. Protect the surface of the product with cloth if you are using any product with rubber feet or
base.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OT-92
REVISED NOV 05, 2014
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 D Back 1
B Side frame
(L-R) 2
E Top crossbar 1
F Bottom
crossbar 1
C Bottom
shelf 1
G Drawer 2
HARDWARE LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Long bolt
(M6x35mm)
6
5 Screw
(M4x35mm) 12
2 Flat washer
(6.5x13mm) 6
6 Knob 2
3 Lock washer
(6.5x11mm) 6 7
Pan head screw
(M4 x 30mm) 2
4 Allen key
(4x80mm) 1

ITEM NO.: OT-92
REVISED NOV 05, 2014
Printed in Vietnam
- 4 -
STEP 1
Attach back (D) and bottom shelf (C) to side frames (B) with bolts (1), washers (2) and (3) as shown
below. Tighten with Allen key (4).
Attach top crossbar (E) and bottom crossbar (F) to side frames (B) with screws (5) as shown below.
Tighten with a screwdriver.

ITEM NO.: OT-92
REVISED NOV 05, 2014
Printed in Vietnam
- 5 -
STEP 2
Attach the unit to top (A) with screws (5) as shown below. Tighten with a screwdriver.
STEP 3
Insert drawer (G) into the unit. Attach knob (6) to the drawer front with pan head screws (7) as shown
below. Tighten with a screwdriver.