International Concepts VISTA BE-65 User manual

ITEM NO.: BE-65
ISSUED JUL 02, 2019
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: VISTA SLATBACK BENCH
: BE-65

ITEM NO.: BE-65
ISSUED JUL 02, 2019
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: BE-65
ISSUED JUL 02, 2019
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Back
1
B
Seat Frame
1
C
Front Leg
(L - R)
2
D
Side stretcher
(L –R)
2
E
Middle
Stretcher
1
F
Seat
1

ITEM NO.: BE-65
ISSUED JUL 02, 2019
Printed in Vietnam
- 4 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Long Bolt
(M6 x 80mm)
4
2
Medium Bolt
(M6 x 60mm)
4
3
Short Bolt
(M6 x 40mm)
4
4
Long Screw
(M4 x 50mm)
4
5
Medium Screw
(M4 x 35mm)
7
6
Short Screw
(M3.5 x 15mm)
2
7
Lock Washer
(6.5 x11mm)
12
8
Flat Washer
(6.5 x19mm)
12
9
Allen Key
(M4 x 30mm x 110mm)
1
STEP 1
Attach seat frame (B) to the back (A) with bolts (1) and (3), and washers (7) and (8) as shown below.
Tighten with Allen key (9).

ITEM NO.: BE-65
ISSUED JUL 02, 2019
Printed in Vietnam
- 5 -
STEP 2
Attach front legs (C) to the seat frame with bolts (2), washers (7) and (8) as shown below. Tighten
with Allen key (9).
Attach middle stretcher (E) to side stretchers (D) with screws (6). Then attach side stretchers (D) to
front and back legs with screws (4) as shown below. Tighten with a screwdriver.
STEP 3
Attach the seat (C) to top of the seat frame (B) with screws (5) as shown below. Tighten with a screwdriver.