International Concepts BORDEAUX CHAIR WITH WOOD SEAT C-15 User manual

ITEM : C
-
15
REVISED FEB 2, 2012
Printed in Vietnam
- 1 -
ASSEMBLY
INSTRUCTIONS
Description
Item No.
:
BORDEAUX CHAIR
WITH WOOD SEAT
: C-15

ITEM : C
-
15
REVISED FEB 2, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEM
B
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton
during shipment. Please separate, identify, and count all parts and metal hardware. Compare with part list to be
sure all parts are present.
If hardware is missing or you have difficulty assembling this product, please call Toll Free: 1-888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
A Chair back 1
B Seat frame 1
C Side stretcher
(L-R) 2
D Front leg
(L-R) 2
E Seat 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM : C
-
15
REVISED FEB 2, 2012
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
1
Short bolt
(M6x40mm)
3 2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6x80mm)
4 4
Screw
(M4x35mm)
8
5
Flat washer
()6.5x)19mm)
11
6
Lock washer
()6.5x)11mm)
11
7
Allen key
(4mm)
1
STEP 1
Attach seat frame (B) to the back (A) by using bolts (3) and (1) and washers (5) and (6). Tighten with
allen key (7) as shown below.
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.

ITEM : C
-
15
REVISED FEB 2, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach front legs (D) to the seat frame with bolts (2), washers (5) and (6) .Tighten with allen key (7).
Place side stretchers (C) between front and back legs, use the screwdriver to tighten the
screws (4) as shown below.
STEP 3
Attach the seat (E) to top of the seat frame (from Step 2) by using screws (4). Tighten with a
screwdriver.