INTERSPIRO DIVATOR User manual

Disinfection
Spiromatic and Divator mask with breathing valve
Important:
• Always start by washing the mask and breathing valve in accordance with the user
manual and/or separate washing instruction.
• The mask and breathing valve must be disinfected separately.
• Use the disinfectant recommended by Interspiro.
• The Interspiro disinfectant is highly flammable, read the safety data sheet.
• Make sure that there is good ventilation.
• Use the protective equipment stipulated by your organization to protect against virus exposure.
Disinfection of the mask
5 min
• If applicable, open the hatch on
masks tted with Divator hatch
and Spirohatch.
• Place the mask in the disin-
fectant, make sure that the entire
mask is covered.
• Leave the mask in the disin-
fectant solution for 5 minutes.
Longer exposure times might
cause damage to the equipment.
Max 55°C
!
55204A01
• Thoroughly rinse the mask
in fresh water.
• Shake o excess water.
• Leave the mask to dry. A
drying cabinet can be used,
maximum 55 °C for 2 hours.

5 min
Disinfection of the breathing valve
Max 55°C
!
A
55204A01
• Remove the cover from the
breathing valve. Press on
the threads to remove the
diaphragm assembly. Re-
move the sealing disc and
the spring with the guide
disc.
• Attach a breathing hose to
the breathing valve. Make
sure to not get any disin-
fectant into the open end of
the hose.
• Put the parts in the disin-
fectant and move it all
around to get
disinfectant on all surfaces.
• Leave the parts in the
disinfectant for 5 minu-
tes. Longer exposure time
might cause damage to the
equipment.
• Remove all parts from
the disinfectant and
pour out any remaining
disinfectant.
• Put all parts in fresh
water and move it
around to get rid of any
disinfectant residues.
• Make sure that the thin, large
O-ring on the diaphragm
assembly still is in place.
• Remove the breathing hose
from the breathing valve.
• Position the breathing valve
with the openings in a position
which makes it easier for the
moisture to evaporate.
• The diaphragm assembly must
not be flat during drying. Place
it on an item (A) that keeps the
diaphragm expanded to allow
moisture to evaporate.
• Make sure there are no visible
moisture on the breathing
valve aer drying. If necessary
let it dry longer.
1 2
3 4
5 6 • Dry all parts, maximum 55 °C for at least 2 h.
• Remove the parts
from the water
and shake o any
remaining water.