ITRON OpenWay Riva User manual

Revision 1.0 Page 1
Itron OpenWay® Riva™ ACT Module
U ER MANUAL
Note: To maintain the compliance with radiation protection, place the product at least 20 cm from nearby
persons.
The operation of the OpenWay® Riva™ ACT Module assumes you start with a CGR1240 as shipped from
Cisco. The CGR1240 will look like the picture below assuming there is a cellular backhaul module installed
in lot 3:

Revision 1.0 Page 2
1.0 Installing the OpenWay® Riva™ ACT Module
The OpenWay® Riva™ ACT Module will then be inserted into lot 6 as shown in the
picture below:

Revision 1.0 Page 3
1.1 Connect the QMA cable to the connector on the OpenWay® Riva™ ACT Module that is closest to the
center of the CGR.

Revision 1.0 Page 4
2.0 Configuring the CGR
Now plug in the CGR1240 and wait for about 20 minutes while the CGR boots up and configures itself.
2.1 Connect the U B cable to a PC using the RJ45 Ethernet to DB9cable provided using a DB9 to U B adaptor
as shown below:

Revision 1.0 Page 5
2.2 Open Tera Term or a comparable software terminal emulator program. et the baud rate on the PC to
9600 baud as shown below:

Revision 1.0 Page 6
2.3 Type the following commands into Tera Term:
show_module enable
#hw-module_poweroff_6 (powers off lot 6)
#no_hw-module_poweroff_6 (powers on lot 6)

Revision 1.0 Page 7
2.4 CGR with OpenWay® Riva™ ACT Module is now ready to accept instructions for the application code to
run.
3.0 Configuring the ACT PLC Coupler

Revision 1.0 Page 8
ACT PLC Coupler should be attached to the adaptor plate as shown below:
3.1 Connect one end of the AC Input Cable 010415-06 as shown below:

Revision 1.0 Page 9
3.2 Connect one end of the AC Output cable 010415-08 as shown below:

Revision 1.0 Page 10
3.3 Connect one end of the PLC Cable 010415-07 as shown below: