J D Williams New England 3 Tier Caddy QN855 User manual

Dimensions
Width - 33cm
Depth - 24cm
Height - 92cm
Important– Please read these instructions fully before starting assembly
Assembly Instructions- please keep for future reference
464/3944
New England 3 Tier Caddy
Issue 1 - 16/05/2016
QN855

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
page 2
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
•Assemble the item as close
room) as possible.
•Assemble on a soft level
surface to avoid damaging the
• Parts of the assembly will be
easier with 2 people.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
•This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
•Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
tightend properly.
Handy Hints
• We do not
recommend the use
of power drill/drivers
for inserting screws,
as this could damage
the using. Only use hand
screwdrivers

Middle Box x 1 (20.5 x 30 x 12 cm)
3
Top Box x 1(20.5 x 30 x 6 cm)
2
Top Bar x 1
(22 x 3 cm)
1
5
Bottom Box x 1
(23.5 x 33 x 19.3 cm
4(90.5 x 3 cm)
Side Bar
Components -Panels
Please check you have all the panels listed below
Components - Fittings
Note:
may be supplied than are required.
Tools required
Phillips screwdriver
(medium & large)
AB
25mm Screw x 14 Protective feet x 4 Hole sticker x 14
C

3

4
Assembly Instructions
Step 1
Step 2
A
1
2
3
4
A
5
A
A
A
A
A
A
5
1
2
3
4
5
A
A
A
A
A
A
A
5
A
1. To Upright bar 5 ,
Connect Handle 1
and storage boxes 2
, 3 and 4 using 7 x
Screw A
1
5
2
3
A
1. Attach Second
upright bar 5 to the
caddy using 7 x screw
A
A
5