jbc DM Series User manual

DM
4 TOOLS CONTROL UNIT
www.jbctools.com

HEAT MANAGEMENT
2
DM / 4 TOOLS CONTROL UNIT
DM-2B / DM-1B / DM-9B
CONTROL UNIT
MS-A
DESOLDERING PUMP
DR-SC
DESOLDERING STAND
Connectable tools: T210, T245, PA120, HT420, AP130, DR560 and DS360.
Connectable modules: MS, MV and MN.
INSTALLATION
Power Cord
Socket
USB Connector
to PC
JBC stations intelligently manage the tool temperature:
Work mode: When the tool is used, pre-set work temperature is 350º C.
Sleep mode: When the tool is in the stand, the temperature goes down to 180º C (depending of the configuration).
Hibernation mode: After longer periods of inactivity (pre-set i.e 30 minutes), the power is cut off and the
tool cools down to room temperature.
Heat management increase tip life which reduces cost of ownership.
CONTROL UNIT POWER CORD MANUAL
DM
4 TOOLS CONTROL UNIT
ww w.j bcto ol s.co m

Main menu
Counters
Tool settings
Exit
1 Reset settings
2 Station settings
3 Tool settings
1 Plugged hours 0
2 Working hours 0
3 Sleep hours 0
1 Fix one temp -----
2 Temp levels set OFF
3 Sleep delay 0 min
4 Counters
5 Program version
4 Hibernation hours 0
5 No tool hours 0
6 Sleep cycles 0
7 Desold cycles 0
4 Sleep temp 180
0
C
5 Hibernation delay 3 0 min
6 Temp adjust O
O
C
Tool DR
Port 1 Port 1/4
Port 1/4
Tool DR
Port 1
Back
Back
0
c
Selected temp. 350
o
C
Power 10%
350
Station settings
1 Temp unit Celsius
2 Maximum temp 400
0
C
3 Minimum temp 200
0
C
4 Nitrogen mode OFF
5 Help text OFF
6 Beep ON
7 Power limit 160W
8 Change PIN
Back
3
CONTROL SCREEN
SETTINGS MENU
Decrease & move down Increase & move up
Tip temperature
% Instant power supplied to the tool
Access Menu
& Conrm Selection
ORIGINAL PIN: 0105

WARRANTY
JBC’s 2 years warranty guarantees this equipment against all
manufacturing defects, covering the replacement of defective parts
and all necessary labour.
Warranty does not cover product wear due to use or mis-use.
In order for the warranty to be valid, equipment must be returned,
postage paid, to the dealer where it was purchased enclosing this
fully filled in, sheet.
www.jbctools.com
SERIAL Nº
STAMP OF DEALER
DATE OF PURCHASE
0008871-0712
TECHNICAL SPECIFICATIONS
- Temperature selection from 90°C (190°F) to 450°C (840°F) (±5%).
- Output Peak Power: 160W.
- Safety transformer, mains separator and double isolation.
- DM-2B 230V 50/60Hz. Input fuse: 3,15A. Output: 23,5V.
- DM-1B 120V 50/60Hz. Input fuse: 6A. Output: 23,5V.
- DM-9B 100V 50/60Hz. Input fuse: 8A. Output: 23,5V.
- Total weight of unit: 4,4 Kg (9,7 lb.)
- Complies with CE standards on electrical safety, electromagnetic compatibility
and ESD protected housing “skin effect”.
- RoHS compliant.
- Equipotential connector and the tool tip are connected to station mains ground supply for ESD protection.
This product should not be
thrown in the garbage.