John Thomas OF-67X User manual

ITEM NO.: OF-67X
REVISED APR 03, 2019
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: HAMPTON DESK
: OF-67X

ITEM NO.: OF-67X
REVISED APR 03, 2019
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws, bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OF-67X
REVISED APR 03, 2019
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top
1
C
Side Frame
(L-R)
2
B
Crossbar
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short Bolt
(M6 x 35mm)
4
6
Allen key
(M4 x 30mm x 110mm)
1
2
Long Bolt
(M6 x 60mm)
2
7
Wooden knob
(30 x 30mm)
1
3
Lock Washer
(6.5 x 11mm)
6
METAL KNOB
(30 x 30mm)
GOES WITH
FINISHED ITEM
ONLY.
1
4
Large Flat Washer
(6.5 x 19mm)
4
8
Pan head screw
*Metal knob: (M4x22mm)
*Wooden knob: (M4x25mm)
1
5
Small Flat Washer
(6.5 x 13mm)
2
9
Screw
(M4 x 45mm)
2

ITEM NO.: OF-67X
REVISED APR 03, 2019
Printed in Vietnam
- 4 -
STEP 1
Attach side frames (B) to the top (A) with bolts (1) and (2), and washers (3), (4) and (5) as shown
below. Tighten with Allen key (6).
Insert crossbar (C) into side frames (B) and attach with screws (9) as shown below. Tighten with a
screwdriver.

ITEM NO.: OF-67X
REVISED APR 03, 2019
Printed in Vietnam
- 5 -
STEP 2
Attach knob (7) to front of drawer with pan head screw (8) as shown below. Tighten with a screwdriver.