Kessel 80888 User manual

Replacement Probe + Adaptor (Article Number 80888)
For all Staufix Premium and Ecolift backwater valves / pumps for the following control units:: 80073, 28073, 80071, 28071, 21071
und Ersatz Sonden 80085, 80086, 80087, 80088
Please follow the safety and product information contained in the Installation and User's manual
• When replacing the pump pro e the red plastic adaptor must e properly connected (attached and turn a quarter turn counter clockwise). Also take the
small red sticker and stick it to the pro e ca le near the connection plug (see photos 1-3).
• When replacing the motor pro e the lack plastic adaptor must e connected (see photos 4-6)
010-880 page 1 08/2011
• These raised tips prevent the
pro e from eing connected im-
properly and must always point
upward.
①②③④⑤⑥
Contents of delivery
If required on-site (for example for conduit pipes, cable length changes, etc.)
Unscrew the
lack connector.
Remove plug. Remove any
residue.
Insert ca les until they
contact ack of plug.
Adaptor installation instructions:
Restrip ca les.
Continued page 2
alid beginning Jan 2011

Kabel Jack
lue 1
white 2
lack 3
alid up to 1996
Cable description: Blue cable on
blue mark, white cable on white
mark, black cable on black mark
alid from 1996 to 2010
If required on-site (for example for conduit pipes, cable length changes, etc.)
Connect ca les to
proper position (see
description to the
right)
Cut off any ca le
portions which are
sticking out
Re-screw the lack
connector to the
plug
010-880 page 2 08/2011
Accessories:
10 meter probe cable extension -
Article Number 80889
Attention: connection of
probe on for control
units up to 1996
Red and green circuit oard
Arrow on plug
should match trian-
gular tip on threads.
Continues on page 3

①For models January 2011 and newer
Adaptor for all pump optical sensors
For models up to Decem er 2010
Adaptor for all Staufix FKA and Pumpfix F
optical sensors for DN 100 (OD 110 mm) models
②For models January 2011and newer
Adaptor for all motor optical sensors
③For models up to Decem er 2010
Adaptor for all Staufix FKA and Pumpfix F optical sensors for DN 125
(OD 125 mm) and DN 150 (OD 160 mm) models.
Must e used in com ination with the red adaptor (adaptor ① is
inserted into the top of adaptor ③).
• The raised edge on the adaptors are to assure the adaptor
ist installed properly and should always e pointing up.
①② ③
Installation note adaptor:
General: The adaptors are used to fasten the new
Pro es without mounting rackets.
010-880 page 3 08/2011
Use each adaptor depending on probe type and the backwater system (see 1-3)