Keys Fitness Power System KPS-SCC User manual

OWNER’S MANU AL
KPS-SCC
S INGLE C ABLE C OLUMN
Questions?
Call our toll free Keys Fitness Helpline
1-800-683-1236

THANK YOU for making this Power System unit a part of
your exercise program. Keys Fitness and our Power System
Series assures the very best in value, appearance, durability
and biomechanics.
This manual will guide you through the assembly process. If at any time
you are having trouble with the assembly or use of this product, then
please contact us at our Keys Fitness Helpline. We have trained service
technicians on site to take care of you, our valued customer.
POWER SYSTEM SERIES
MODEL: KPS-SCC
QUESTIONS?
CALL
1-800-683-1236
Monday-Friday
8:30-5:30 Central Time
When calling please have the following product information available:
• Product Series
• Model #
• Part Number
• Part Description
REGISTRATION CARD
To avoid unnecessary delays in warranty parts and to insure that a perma-
nent record of your purchase is on file with our company, be sure to send
in the warranty registration card or register on-line at www.keysfitness.com
within 10 days of purchase.

BEFORE YOU START
Prior to assembly, remove components from the box and verify that all the listed parts
were supplied.
Before using this unit or starting any exercise program, consult your physician. This is
especially important for persons over the age of 35 and/or persons with pre-existing
health problems. Keys Fitness Products LP assumes no responsibility for personal
injury or property damage sustained by or through the use of this product.
It is the owner’s responsibility to ensure that all users of this unit have read the Owner’s
Manual and are familiar with safety information and precautions.
SAFETY INFORMATION WARNING!
u
SAFETY PRECATIONS
• This Power System unit should only be used on a level surface and is intended for
indoor use only. Keys Fitness recommends an equipment mat be placed under the
unit to protect the floor or carpet and for easier cleaning.
• Wear comfortable, good-quality walking or running shoes and appropriate clothing.
Do not use this unit with bare feet, sandals, socks or stockings!
• Always examine your unit before using to ensure all parts are in working order.
• Do not leave children unsupervised near or on the unit.
• Service to your Power System unit should only be performed by an authorized serv-
ice representative, unless authorized and/or instructed by a Keys Fitness technician.
Failure to follow these instructions will void the warranty.

ASSEMBLY
STEP 1
v
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Connect the U Base (1) to the Middle
Base (2) with Bolts (32), Washers (41)
and Nylon Lock Nuts (42).
STEP 2
Attach the Rear Upright (4) to the Rear
Base (3) with bolts (31), Washers (41)
and Nylon Lock Nuts (42).

ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
w
STEP 3
Attach Middle Base (2) to Rear Base
(3) with Bolts (32), Washers (41) and
Nylon Lock Nuts (42).
Insert Guide Rods (8) into Middle Base
(2). Make sure that the threaded end
of the Guide Rods points up.
Slide Weight Bumbers (45) down to
bottom of Guide Rods (8).
Slide qty 9 of the 10 lb plates (27) onto
the guide rods.
Slide qty 10 of the 5 lb plates (28) onto
the guide rods.
Slide selector rod assembly onto guide
rods.

x
STEP 4
Attach Slide Frame (6) onto Middle
Base (2) with bolt (31), Washers (41)
and Nylon Lock Nut (42).
Place Slide Frame (6) over Guide
Upright (5) and secure with Pop Pin.
Attach Top Frame (7) to Guide Upright
(5), Guide Rods (8) and Rear Upright
(4) as shown.
ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

STEP 5
Complete Cable (11) and Pulley
assembly as shown.
ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
y

z
STEP 6
Attach Shrouds to frame using Allen
Bolts (38) and Washers (40).
ASSEMBLY
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

PARTS LIST
#DESCRIPTION QTY
1"U" base 1
2middle base 1
3rear base 1
4rear upright 1
5guide upright 1
6slide frame 1
7top frame 1
8guide rod 2
9weight shroud 2
10 double pulley block 1
11 cable 1
12 swing pulley block 1
13 select rod 1
14 jam nut 1
15 pop Pin 1
16 big pulley 114 5
17 small pulley 89 3
18 lat strap 1
19 ankle strap 1
20 end cap 50.8 4
21 guide sleeve 63.5x?50.8 2
22 plug 50.8x76.2 1
23 plug 25 1
24 grip 1
25 gear hook 8 1
26 top plate 1
27 weight plate 10LBS 9
28 weight plate 5LBS 10
29 weight pin 1
30 bolt M10x70 4
31 bolt M10x65 4
32 bolt M10x75 4
33 bolt M10x50 5
34 bolt M10x35 1
35 bolt M10x55 1
36 bolt M10x25 2
37 bolt M10x140 1
38 allen bolt M8x10 4
39 chamfer bolt M12x35 1
40 washer 8 4
41 washer 10 40
42 nylon lock nut M10 20
43 small bushing 2
44 pulley spacer 4
45 weight bumper 2
46 allen wrench S=6 1
{

EXPLODED VIEW
“