Kimball Office Footprint Interworks EQ User manual

Footprint® Support 1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
1847179, Revision D
Assembly Instructions
Interworks EQ® Panel Mounted
Worksurface
Tools Required
 Tape Measure
 Drill with torque option
 #2 Philips head bit
 #2 R-2 square screwdriver bit
Note: Panel mounted worksurface brackets are provided in two
types, left or right. (Figures A & B). The top of the brackets
should be located 22 3/4 " from the top of the wireway cover
for standard height and 19 3/4" for typing height. (Figure C).
Installation
Figure A Figure B
Figure C
Figure D Figure E
Figure F
Left
1. Insert hook on the top of bracket into the panel frame slot
at a 45° angle. (Figure D).
2. Push the top of the bracket downward allowing locking tab
to engage in the panel slot. (Figure E).
3. Install a bracket at each panel joint in the worksurface
layout.
Note: When installing the worksurface brackets along the
center, you must alternate left brackets and right brackets to
prevent a shortage of brackets. (Figure F). If you run short of
either left or right brackets, refer to alternate installation
diagram. (Figure G).
Note: A structural cantilever must be used in place of the
standard worksurface brackets when the open kneespace is
greater than 48" for 1 3/16" surfaces and 60" for 1 9/16" sur-
Right
Figure G

Footprint® Support 2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
1847179, Revision D
Assembly Instructions
Interworks EQ® Panel Mounted
Worksurface
Installation (continued)
Figure H Figure I
Figure J
Figure K Figure L
Figure M
4. Place worksurface on clean, solid surface, back side facing
up. Install the flat brackets on the "main" worksurface,
approximately 2" from front edge and approximately 6"
from back edge of the adjoining worksurface using the
screws provided. (Figure H). Ensure that the flat bracket
attachment does not interfere with other brackets or
components. Two flat brackets are required to join surfaces
end to end or at a right angle.
5. Square all panels to aid in alignment and consistent reveals
between worksurfaces and panels. (Figure I).
6. Lay the worksurface on the brackets. (Figure J).
Tip: Use an undersurface component as additional support
until the worksurface bracket is secured to the surface.
Figure N
7. Lay adjoining worksurface onto brackets.
Note: When attaching two surfaces at a right angle, there
will be a 1/8" gap between the wire manager and panel.
(Figure K). If there is no wire manager, the surfaces should
align. (Figure L).
8. Attach adjoining worksurface to the flat brackets with
screws provided. (Figure M). Eight screws required per
bracket.
9. Adjust worksurface location to ensure alignment of surface
joints with panel reveals, if applicable, and control gaps
between panel and edges of worksurfaces. DO NOT press
wire manager into panel.
10. Attach the worksurfaces to the worksurface brackets using
the screws provided. (Figure N). A minimum of two
screws