Guide Lectern Assembly (TFL Hinged Door/Open File Pedestal)
Tools Required
• Drill Tape Measure
• Allen Wrench Set #2 Phillips Head Bit Drive
• 1/8” Drill Bit
Hardware Required for Guide Lectern with Metal
Pedestals
(1) – Guide Lectern X-Blade Base (54K2028CFXMP)
(1) – Podium Surface (54K1916WS*)
(1) – Podium Column (54K1202PCP)
(1) – Lectern Pedestal (TFL)
(2) – 3/8-16 x 1.5” PH Hex Machine Screws
(20) – #10-0.75” PHP Wood Screws
Installation
1. Place the TFL pedestal and place upside-down on a non-
marring surface.
2. Place the Guide Lectern X-Blade Base upside-down,
aligning the two pre-machined holes with two (2) of the
corner holes in the X-Blade Base as seen in Figure 1.
Drive 2 #10-0.75 PHP Wood Screws into the pre-machined
holes and then drive #10-0.75 PHP Wood Screws through
the remaining holes on the X-Blade Base into the underside
of the pedestal.
3. Place the Podium surface upside-down on a non-marring
surface, then place the Podium Column upside-down on the
backside of the Podium surface and center it as seen in
Figure 2 on the next page.
4. Pre-drill the holes, as seen fit, to a depth of a few
millimeters, and drive eight (8) #10-0.75” PHP Wood
Screws through the holes in the Podium Column plate, into
the Podium surface.