KitchenAid KSVC 3610 User manual

Instructions for use

3
Before using the appliance 4
Advice for safeguarding the environment 5
Precautions and general recommendations 6
Appliance description 6
Control panel 7
Preliminary instructions for use 7
Preparing vacuum bags and containers 9
Machine operation indications 11
Routine maintenance reminders 12
Messages and Reminders 13
Troubleshooting guide 15
After-sales Service 16
General reminders 17
Electrical connection 17
KitchenAid front panel in stainless steel
with anti-fingerprint surface finish 18
Technical data 18

44
Your new appliance is designed exclusively for
domestic use.
To get the most out of your new appliance, read
the user handbook carefully as it contains a
description of the appliance and some useful tips.
Keep this handbook for future consultation.
1. After unpacking, make sure that the appliance is
undamaged and that the lid closes perfectly. Any
damage must be reported to the dealer within
24 hours of delivery of the appliance.
2. Make sure the appliance is installed and
connected to the electricity supply by a qualified
technician in accordance with the
manufacturer's instructions and in compliance
with local regulations.
3. This appliance must be used exclusively for the
purpose for which it was designed and built,
namely for vacuum packing of foodstuffs. Any
other use is to be considered improper and
potentially dangerous.
4. Before starting up the machine, clean the
vacuum chamber thoroughly with a soft, damp
cloth. Repeat several times, rinsing the cloth in
clean water each time. Do not use harsh
detergents, steel scourers, scrapers or any
abrasive, acidic or aggressive substances which
could damage the surfaces of the vacuum
chamber irreparably.
5. Check that no oil has leaked from the machine
during transit or installation. If there is any trace
of an oil leak from the machine, contact an
authorized After-sales Service.
Before using the appliance

5
1. Packing
The packing materials are 100% recyclable and are
marked with the recycling symbol . Disposal
must be carried out in accordance with local
regulations. The packing materials (plastic bags,
polystyrene parts, etc.) are potentially hazardous
and must be kept out of the reach of children.
2. Scrapping/Disposal
The appliance is manufactured using recyclable
materials.
This appliance is marked in compliance with
European Directive 2002/96/EC, Waste Electrical
and Electronic Equipment (WEEE).
By ensuring that the appliance is scrapped suitably,
you can help prevent potentially damaging
consequences for the environment and health.
The symbol on the appliance or accompanying
documentation indicates that this product should
not be treated as domestic waste but must be
taken to an appropriate collection point for
recycling WEEE.
When scrapping the appliance, make it unusable by
cutting off the power cable and remove the lid so
that children may not easily climb inside.
Scrap the appliance in compliance with the local
regulations on waste disposal, taking it to a special
collection centre; do not leave the appliance
unattended even for a few days, since it is a
potential source of danger for children.
For further information on the treatment, recovery
and recycling of this appliance, contact your
competent local office, the household waste
collection service or the shop where you
purchased it.
Declaration of conformity
This appliance has been designed, manufactured
and retailed in compliance with:
• the safety objectives of the Low Voltage
Directive 2006/95/CE (which replaces Directive
73/23/CEE as amended);
• the protection requirements of "EMC" Directive
2004/108/EC.
Electrical safety of the appliance can only be
guaranteed if it is correctly connected to an
efficient, approved earthing system.
Advice for safeguarding the environment
5