Klarstein Tomahawk 4.2-SBG User manual

2531-18
10033512
Tomahawk 4.2-SBG
Barbecue Grill

3
EN
Technical Data 4
Safety Instructions 5
Overview 6
Installation 7
Connection to Appliance 15
Checking for Leaks 16
Lighting Instructions for Barbecue 17
Cleaning and Care 19
Troubleshooting 20
Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and
take care of the following hints on installation and use to avoid technical damages.
Any failure caused by ignoring the items and cautions mentioned in the operation and
installation instructions is not covered by our warranty or any liability.
CONTENTS

4
EN
TECHNICAL DATA
Item number 10033512
Total heat input 20.7 kW (1507 g/h)
Gas category I3 + (28-30/37) I3B/P (30) I3B/P (50)
Types of gas Butane (G30) Propane (G31) Butane, propane or their mixtures
Gas pressure 28-30 mbar 37 mbar 28-30 mbar 50 mbar
Grill burner
injection size 0.9 mm 0.9 mm 0.9 mm 0.8 mm
Side burner
injector size 0.85 mm 0.8 mm 0.85 mm 0.75 mm
Rear burners
injector size 0.9 mm 0.88 mm 0.9 mm 0.8 mm
I3 + (28-30/37) BE, FR, IT, LU, IE, GB, GR, PT, ES, CY, CZ, LT, SK, CH, SI, LV
I3B/P (30) LU, NL, DK, FI, SE, CY, CZ, LT, MT, SK, SI, BG, IS, NO, TR, HR, RO, IT, HU, LV
I3B/P(37) PL
I3B/P (50) AT, DE, CH, LU, SK
Identication number 2531CS-0117
Important Notes • WARNING: accessible parts may be very hot. Keep young children
away.
• Read the instructions before using the appliance.
• Use the appliance in well-ventilated areas.
• Any modications of the appliance may be dangerous.
• Turn off the gas supply at the gas cylinder after use.
Chal-Tec GmbH
Wallstraße 16
10179 Berlin
Germany
2531-18

6
EN
OVERVIEW
1 Warming plate (1 pc)
2 Cooking grill (2 pcs)
3 Flame tamer (3 pcs)
4 Body (1 pc)
5 Left side table (1 pc)
6 Left trolley panel (1 pc)
7 Left door (1 pc)
8 Beam (1 pc)
9 Trolley bottom panel (1 pc)
10 Bracket (1 pc)
11 Castor feet (2 pcs)
12 Rollers (2 pcs)
13 Wheels with brakes (2 pcs)
14 Right trolley panel (1 pc)
15 Right door (1 pc)
16 Trolley back panel (1 pc)
17 Right side table (1 pc)
18 Handle
19 Hooks (3 pcs)
20 Grease tray

12
EN
11
10

14
EN
14
15

15
EN
CONNECTION TO APPLIANCE
• This appliance is only suitable for use with low-pressure butane or propane gas or
LPG mixtures, tted with the appropriate low-pressure regulator via a exible hose.
• The hose should be secured to the regulator and the appliance with hose clips.
Make sure the exible hose cannot come in contact with hot surfaces and avoid
twisting.
• Use a suitable regulator that is certied to BSEN 12864 or EN 16129. Make sure
the regulator and exible hose comply with local code.
Regulator and hose
Use only regulators and hoses approved for LP Gas at the above pressures. The life
expectancy of the regulator is estimated at 2 years.
The use of the wrong regulator or hose is unsafe; always check that you have the correct
items before operating the barbecue.
The hose used must conform to the relevant standard for the country of use. Worn or
damaged hoses must be replaced. Ensure that the hose is not obstructed, kinked, or in
contact with any part of the barbecue other than at its connection.
For exible hoses
• Avoid twisting the exible hose when the appliance is in use. The length of the
exible hose shall not exceed 1.5 m. In Finland, the length shall not exceed 1.2m.
The hose should certied according to the applicable EN Standard and comply
with local code.
Storage of appliance
• Storage of an appliance indoors is only permissible if the cylinder is disconnected
and removed from the appliance. When the appliance is not to be used for a
longer period of time it should be stored in its original packaging in a dry and dust
free environment.
Gas cylinder
The gas cylinder should not be dropped or handled roughly! If the appliance is not in
use, the cylinder must be disconnected. Replace the protective cap on the cylinder after
disconnecting the cylinder from the appliance. The gas cylinder must be located outside
the body of the appliance.
Always connect or replace the cylinder in a well-ventilated area and away from any
source of ignition, never in the presence of a ame, spark or heat source.
Cylinders must be stored outdoors in an upright position and out of the reach of children.
The cylinder must never be stored where temperatures can reach over 50 °C. Do not
store the cylinder near ames, pilot lights or other sources of ignition. DO NOT SMOKE.
This barbecue is designed for use outdoors, away from any ammable materials. It
is important that there are no overhead obstructions and that there is a minimum

16
EN
distance of 1 m from the side or rear of the appliance. It is important that the
ventilation openings of the appliance are not obstructed. The barbecue must be
used on a level, stable surface. The appliance should be protected from direct draughts
and shall be positioned or protected against direct penetration by any trickling water
(e.g. rain).
Make sure that the gas cylinder compartment (if any) is not obstructed, keep it ventilated
and clean.
CHECKING FOR LEAKS
• Make 2-3 uid ounces of leak-detecting solution by mixing one part washing-up
liquid with 3 parts water.
• Ensure the control valve is “OFF”.
• Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the
connections are secure then turn ON the gas.
• Brush the soapy solution onto the hose and all joints. If bubbles appear you have a
leak, which must be rectied before use.
• Retest after xing the fault
• Turn OFF the gas at the cylinder after testing.
• If leakage is detected and cannot be rectied, do not attempt to cure leakage but
consult your gas dealer.

17
EN
LIGHTING INSTRUCTIONS FOR BARBECUE
1. Open the hood of the barbecue before attempting to light the burners.
2. Turn all the control knobs clockwise to 'OFF' position.
3. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the regulator.
Check with the use of soapy water for any gas leakage between the bottle and the
regulator.
4. Push down the front left control knob and keep pressing whilst turning anti-clockwise
to the 'HIGH' position (a clicking sound will be heard). This will light the left hand
burner. Observe if the burner has lit. If not repeat this process.
5. If the burner has not lit after retrying wait 5 minutes and repeat step 4.
6. Adjust the heat by turning the knob to the High/Low position.
7. If the burner does not light, light the appliance with a match using the lighting hole
in the side of the appliance. Consult your gas dealer to rectify the ignition.
8. To light the remaining burners in sequence from left to right, repeat 4 above. The
cross-lighting channel between the burners will light the burner adjacent to it.
9. To turn the barbecue ‘OFF’ turn the cylinder valve or regulator switch to the ‘OFF’
position and then turn the control knob on the appliance clockwise to the ‘OFF’
position.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also
turn the cylinder valve off. Wait ve minutes before attempting to relight with ignition
sequence.
• Before cooking for the rst time, operate the barbecue for about 15 minutes with the
lid closed and the gas turned on LOW. This will 'heat clean' the internal parts and
dissipate odour from the painted nish.
• Clean your barbecue after each use. DO NOT use abrasive or ammable cleaners,
as it will damage the parts of the product and may start a re. Clean with warm
soapy water.
• WARNING: Danger of burns.
• Accessible parts may be very hot. Keep young children away from the hot
appliance at all times (even while it is cooling down).
• It is recommended that protective gloves (e.g. oven gloves) be used when handling
particularly hot components.

18
EN
How to use the electric igniter
1. Unscrew the igniter button cap(A),install a “AAA” battery (B).
2. Control knob must be in the 'OFF' position.
3. Connect propane cylinder (see manual).
4. Push and turn control knob counter-clockwise to 'MAX'.
5. Press the igniter button repeatedly to light rear burner
6. Release control knob after 15 seconds
7. If ignition does not occur in 45 seconds, push and turn burner control knob to
'OFF', wait 5 minutes, and repeat lighting procedure.

20
EN
TROUBLESHOOTING
Problem Possible Cause Solution
Burners will not light using
the ignition system.
LP gas cylinder is empty. Replace with full cylinder.
Faulty regulator Have regulator
checked or replace.
Obstructions in burner. Clean burner.
Obstructions in gas
jets or gas hose.
Clean jets and gas hose.
Electrode wire loose
or disconnected on
electrode or ignition unit.
Reconnect wire.
Electrode or wire is
damaged faulty push
button igniter.
Change electrode and
wire change igniter.
Burner will not light
with a match.
LP gas cylinder is empty. Replace with full cylinder.
Faulty regulator. Have regulator
checked or replace .
Obstructions in burner. Clean burner.
Obstructions in gas
jets or gas hose.
Clean jets and gas hose.
Low ame or ashback
(re in burner tube-a
hissing or roaring
noise may be heard)
LP gas cylinder
is too small.
Use larger cylinder.
Obstructions in burner. Clean burner.
Obstructions in gas
jets or gas hose.
Clean jets and gas hose.
Windy conditions. Use grill in a more
sheltered position.
Declaration of Conformity
Manufacturer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
Germany
This product is conform to the following European Directives and
Regulations:
Regulation (EU) 2016/426