Knight Team Flip User manual

knightgroup.co.nz
Tools Required: Powered Screwdriver
Assembly Instructions
Team Flip

Page 1
Assembly Instructions
knightgroup.co.nz
Team Flip
• To prevent possible scratches or damage, assemble
the table upside down on a soft surface such as a
blanket, carpet or packaging.
• Attach leg to the top assembly by using bolts, spring
washer, flat washer. Tighten using the allen wrench.
Recommended
2-person Step

Page 2
Assembly Instructions
knightgroup.co.nz
Step 1 Step 2
Step 4
Page 2
Assembly Instructions
Step 3
Ensure the frame is located in the centre of the
worksurface. Fully tighten all 6 screws on each
mechanism.
On all tables with width larger than 700mm, secure
the pull bar with the supplied washer and screw in
the location pictured below (slot end closest to the
pull-bar). Leave screw 1 turn from tight so the pull-
bar can be operated smoothly.
Fit the pull bar to the top side of the mechanism
according to the number corresponding to your
worksurface depth. This number will locate over of
the raised cylinder.
Place the pull bar (a) and cross tube (b) in the cor-
rect location pictured below, slide the 2 end legs in
place, and tighten 2 small screws into the cross tube.
Team Flip
(b)
(a)

Page 3
Assembly Instructions
knightgroup.co.nz
Page 3
Assembly Instructions
Team Flip
Hole Position for Optional Connector
Locked
Unlocked
Drilling Patterns for Team Flip Tables
170mm
C
114mm
B B
138mm 138mm64 64
A
2x 2mmØx12mm h
12x 2.5mmØx15mm h
25mm
Table Length
Table Width
294mm
Width - 700mm A B C
1200-1600mm 796 146 NA
1500-1900mm 1096 146 NA
1800-2200mm 1396 146 NA
Width - 900mm A B C
1200-1600mm 796 246 175
1500-1900mm 1096 246 175
1800-2200mm 1396 246 175
Width - 800mm A B C
1200-1600mm 796 196 125
1500-1900mm 1096 196 125
1800-2200mm 1396 196 125
200 20073 73
1717
17 17
36.5 36.5
1.2mm pilot hole