Knoll Pixel KFXW4818 User manual

PIXEL™ Installation Instructions
Four Leg Tables
Glides or casters
Parts list:
1 Table top
4 Legs (with connectors)
Tools needed:
Allen wrench
Torque wrench
Phillips screwdriver
Hardware:
24 Socket cap head 1/4-20 x 1.00 screws
2 Vertical wire management clips
(clear plastic)
4 Horizontal wire management clips
with wood screws
KFXW4830
KFXW6030
KFXW7230
KFXW4836
KFXW6036
KFXW7236
Rectangular tables:
KFXW4818
KFXW6018
KFXW7218
KFXW4824
KFXW6024
KFXW7224
Square tables:
KFXW3636
KFXW4242
KFXW4848
4AU6006 - Oct 2015
Page 1 of 2
A
A
B
Fig. 1
Please pay close attention to torque requirements.
Step 1.
Position each plastic ganging connector (A) within
the upper casting slot for each leg (B).
* Casters shown

PIXEL™ Installation Instructions
Four Leg Tables
Step 2.
Lay the inverted table top on the floor.
Step 3.
Attach each leg to the table top using Socket cap head
1/4-20 x 1.00 screws (C), 6 per leg, torque: 100 in/lb. For
tables with casters, keep both locking casters (D) on the
same side of the top.
Step 4.
Turn the assembled table into the upright position.
All tables come with 2 vertical wire management clips, 4
horizontal wire management clips and wood screws for
use with optional electrical modules. See separate electri-
cal installation instructions for details.
C
B
D
D
Fig. 2
4AU6006 - Oct 2015
Page 2 of 2