Knoll Pixel KYXW7236 User manual

PIXEL™ Installation Instructions
Y-Leg Fixed-top Tables
Glides or casters
Unboxing
You should have received your top plus two boxes per table.
Box 1 includes:
Leg assemblies, hardware in a red plastic bag, and installa-
tion instructions.
Box 2 includes:
Horizontal rails
Hardware
8 Flat head 1/4 - 20 screws
8 Socket cap 1/4 - 20 screws
4 5/16” Shoulder screws
2 Vertical wire management clips
(clear plastic)
4 Horizontal wire management clips
with wood screws
* Casters shown
Related tables:
KYXW7236
KYXW8436
KYXW9648
Please pay close attention to torque requirements.
Step 1.
Attach the leg assemblies (A) on each end of the two
horizontal rails (B) with flat head 1/4 - 20 screws (C),
4 per rail. Use 5/32” allen wrench, torque: 50 in/lbs
Parts list
1 Table top
2 Leg assemblies
2 Horizontal rails
2 Top brackets
Tools needed
Allen wrenches
Phillips screwdriver
Torque wrench
Fig. 1
C
C
C
C
B
B
A
A
4AU6008 - Oct 2015
Page 1 of 2

PIXEL™ Installation Instructions
Y-Leg Fixed-top Tables
Step 2.
Lay the inverted table top on the floor.
Attach table top brackets (D) to table
top with socket cap head 1/4 - 20
screws (E) 4 per bracket. Use 3/16”
allen wrench, torque: 130 in/lbs
Step 3.
Position the leg and horizontal rail
subassembly (F) on the underside of the
top. Align and attach the leg and hori-
zontal rail subassembly with the table top
brackets (G), using 5/16” shoulder screws
(H), 2 per casting. Use 5/32” allen wrench,
torque: 50 in/lbs.
Step 4.
Turn the table top assembly over into the
upright position.
All tables come with 2 vertical wire
management clips, 4 horizontal wire
management clips and wood screws
for use with optional electronic mod-
ules. See separate electrical installa-
tion instructions for details.
If the table is being used as a
stand-alone piece and the ganging
mechanism will not be used, you can
remove the mechanisms by
unscrewing them.
Fig. 2
E
E
D
D
Fig. 3
G
F
G
H
H
4AU6008 - Oct 2015
Page 2 of 2