Knoll Pixel KTXW7230 User manual

PIXEL™ Installation Instructions
T-Leg Fixed Height Fixed-top Tables
Glides or casters
Unboxing
You should have received your top plus two boxes per table.
Box 1 includes:
T-Leg assemblies, hardware in a red plastic bag, and
installation instructions.
Box 2 includes:
Wire management trough and flip door.
Hardware
4 Socket cap head 1/4”-20 x 1” screws
4 Socket cap head 1/4”-20 x 2” screws
4 Flat head 1/4”-20 x 1/2” screws
10 Socket cap head 5/16”-18 x 1” screws
2 Vertical wire management clips
(clear plastic)
4 Horizontal wire management clips
with wood screws
Related tables:
KTXW6030
KTXW7230
KTXW6036
KTXW7236
C
A
A
C
D
D
B
Fig. 1
Fig. 2
Please pay close attention to torque
requirements.
Step 1.
Slide the flip door (A) in from the end of
the wire management trough groove.
Step 2.
Attach the wire management trough
to the T-legs. Use socket cap head
1/4”-20 x 1” screws (C), 2 per leg, use
5/32” allen wrench, torque: 50 in/lb.
Use flat head 1/4”-20 x 1/2” screws
(D), 2 per leg, use 3/16” allen wrench,
torque: 50 in/lb.
Step 3.
Drop the trough end covers (B) into
the slots on each leg upper casting.
B
Parts list
1 Table top
1 Left T-leg assembly
1 Right T-leg assembly
2 Table top support castings
1 Wire management trough
1 Flip door
Tools needed
Phillips screwdriver
Allen wrenches
Torque wrench
* Glides shown
4AU6003 - Oct 2015
Page 1 of 3

PIXEL™ Installation Instructions
T-Leg Fixed Height Fixed-top Tables
Step 4.
Attach the two table top supports (E) to the trough with
socket cap head 1/4”-20 x 2” screws (F), torque: 50 in/lb, 2
per support.
Fig. 3
F
F
E
E
4AU6003 - Oct 2015
Page 2 of 3

PIXEL™ Installation Instructions
T-Leg Fixed Height Fixed-top Tables
Step 5.
Lay the inverted table top on the floor. Position the leg-
trough assembly on the underside of the top.
Step 6.
Align and attach the brackets with the threaded inserts in
the top using 10 socket cap head 5/16”-18 x 1” screws
(G), torque: 130 in/lb.
Step 7.
Turn the table top assembly over into the upright position.
All tables come with 2 verti-
cal wire management clips, 4
horizontal wire management clips
and wood screws for use with
optional electrical modules. See
separate electrical installation
instructions for details.
If the table is being used as a
stand-alone piece and the gang-
ing mechanism will not be used,
you can remove the mechanisms
by unscrewing them.
Fig. 4
G
G
G
G
4AU6003 - Oct 2015
Page 3 of 3