Knoll 6TD00034 User manual

Islands Collection by Knoll
®Installation Instruction
Islands Collection by Knoll
®
March 19, 2020
Part Number: 6TD00034
Sheet 1
6td00034_1.ai
6td00034_hardware.ai
A
G H J K
B C D E F
HARDWARE LIST
6TD40151
SCR,FLP,1/4-20X2
6TD4010201
SCR,T-F,FL,1/4-20X5/8
5134102
SCR,FLP,#14X1-1/4
6TD40036
GLIDE
6TD40033
GLIDE PAD
6TD4000801
TOP MOUNT (CONE)
6TD40052XX
LEG
6TD4001501 - 29" FOOT
6TD4001502 - 35" FOOT
5122218
SCR,TRP#14X7/8
1B53307XX
STIFFENER
X-Base Conference Tables Assembly - Single-Piece Top
Reference Number: 6TD00034
A
G
H
J
K
D or E or F
A
B
Tools Needed
Drill gun
1. Assembly of X-Base
(see Fig. 1)
1.1 Align the glide pad, item (K), to the one
end of foot, item (J), and secure into
place using 2 (B) screws.
Repeat for all 4 ends.
1.2 Align the foot, item (J), to the one end of
leg, item (H), and secure into place using
4 (A) screws.
1.3 Assemble the glide, item (D), into the
threaded hole of the foot, item (J).
1.4 Reorient the leg assembly so that the
glide pad is facing downwards and the
open end is facing up.
1.5 Align the top mount, item (G), to the open
end of the leg assembly and secure into
place using 4 (A) screws.
Note: Please see Fig. 1A for fastening
sequence. Ensure all screws are
fully seated.
Fig. 1 Fig. 1A
Fastening sequence
1
3
4
2

Islands Collection by Knoll
®Installation Instruction
Islands Collection by Knoll
®
March 19, 2020
Part Number: 6TD00034
Sheet 2
X-Base Conference Tables Assembly - Single-Piece Top
Reference Number: 6TD00034
6td00034_2.ai
2. Installation of Assembled
X-Base with Worksurface
(see Fig. 2)
2.1 Lay worksurface upside down on a soft
non scratching surface, rectangular
worksurface shown for example.
2.2 Center and align assembled leg over the
provided pilot holes and attach using 8
(C) screws.
Note: Be sure to not over tighten screws into
worksurface. Overtightening the screw
can cause the hole to strip.
2.3 Repeat steps 2.1 & 2.2 for the installation
of second base.
2.4 Orient stiffeners (F) as per Fig. 2A, (open
end of stiffeners (F) goes toward middle of
worksurface).
2.5 Center the stiffeners over the provided
pilot holes, attach each stiffener (F) to the
worksurface using (E) screws.
Screw (E) quantity will vary depending on
stiffener (F) size, use all provided pilot
holes.
Fig. 2
Fig. 2A
Orient stiffeners
E
F
F
C