Kohler 16359IN-A-CP User manual

All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time
without notice.
Please leave these instructions for the consumer. They contain important information.
1. Flush the water supply pipes thoroughly to remove debris before installation.
2. The highest working pressure for handspray is 0.5Mpa(5 bar). If it exceeds 0.5Mpa(5 bar), a pressure
reducer is needed. The highest water and environment temperature is 60OC. Please keep handspray
away from heater, or maybe damage it and hurt user.
G1/2"
G1/2"
HANDSPRAY WITH HOSE
1193391IN /Rev. C
16359IN-A-CP

1193391IN /Rev. C
Filter washers(1) provided with shower hose(2) must be installed in
each end of hose(2).Connect shower hose to handspray(3) and the water
supply.
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with
clean soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc.
which could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler handsprays and fittings.
The furriness or debris may cause flow stream distorted or reduce
the flowrate. To clean up the furriness or debris, run water through
the handspray, firmly press or rub your finger back and forth across
the rubber spray holes.
**Color code must be specified when ordering.
1181007-**