Kohler C3-149/K-18649T-HC-0 User manual

Smart Seat
清舒宝智能便盖
C3-149/K-18649T-HC-0
C3-149L/K-77284T-HC-0
C3-149R/K-77817T-HC-0
C3-149T/K-77819T-HC-0
English page 2-7
中 文 页 码 8-13
中国上海市静安区江场三路158号 邮编：200436
：上海科勒电子科技有限公司
中国上海市宝山区丰翔路1955号 邮编：200444
1386539-T01-B

WARNING: Risk of electric shock, fire or personal injury. This
product must be installed safely. Connect only to dedicated
220V~, 50Hz, 10A circuit protected by Ground-Fault Circuit-
Interrupters (GFCI’s) or Earth-Leakage Circuit-Breakers (ELCB’s).
Min water pressure 0.07MPa (dynamic pressure), Max water pressure 0.74MPa.
When install the product in the room, a stop valve shall be installed in a close
proximity. For emergency circumstances, the water inlet valve shall be stopped
without using any tools; otherwise unexpected failure may cause the loss to the
customer.
Do not use attachments not recommended by Kohler Co. such as T-valve etc.
1386539-T01-B
2
Kohler Co.

Warning: Risk of electric shock, fire or personal injury.
This product must be installed safely. Connect only to
dedicated 220V~, 50Hz, 10A circuit protected by
Ground-Fault Circuit-Interrupters (GFCI’s) or Earth-
Leakage Circuit-Breakers (ELCB’s).
220V~, 50Hz, 10A
140mm
20mm
70mm
Kohler Co.
3
1386539-T01-B

Gasket
Insert screw into gasket separately.
Gasket
Gasket
Snap screws into mounting board and toilet mounting holes, move
washer so to snap into the mounting board groove. Pay attention to
the washer direction: bending side upwards for washer close to
hole.
Place each screw into washer, pay attention to the washer direction:
bending side upwards for washer close to the hole.
1386539-T01-B
4
Kohler Co.

Arrow 2
Arrow 1
Arrow 1
Mounting
plate
Slightly lift cover front tip, observe rear bugle slot, guide mounting plate into
the groove (per arrow 1 direction) Align the slot on the mounting plate with the
groove located below the toilet seat.
Slide the seat onto the mounting plate, front tip downwards (per arrow 2
direction) until you feel it snaps into place.
For Toilets without Threaded Inserts:
To adjust cover position, do not remove cover; only loosen screws to adjust
cover and mounting plate position. Tight down the bolts when desired position
is acquired.
For Toilets with Threaded Inserts:
To adjust cover position, remove cover first, readjust mounting plate position.
Once the mounting plate is confirmed, tighten screws, fasten mounting plate,
re-install cover.
Kohler Co.
5
1386539-T01-B

Connect T-valve to water supply system (valve shall be purchased by
customer).
Please use new hose enclosed with tools. Please do not reuse
the old hose.
Remove the orange rubber cap of Bidet inlet valve.
1386539-T01-B
6
Kohler Co.

Ensure if water inlet valve is OPEN.
Kohler Co.
7
1386539-T01-B

最小进水压力0.07MPa(动压), 最大进水压力0.74MPa。
在安装本产品的同一房间中，需要在触手可及的位置安装一个止水阀，
用于紧急情况下，无需借助工具即可切断本产品的进水水路；否则本产
品的意外故障可能会导致用户损失。
警告：触电、火灾或人身伤害的危险。本产品必须安全接地。只能
连接到专用的 220V~，50Hz，10A带接地故障断路器或接地漏电
保护器的电路中。
请不要使用科勒不推荐的附件，如三通等。
1386539-T01-B
8
Kohler Co.

70
20
140mm
警告：触电、火灾或人身伤害的危险。本产品必须安
全接地。只能连接到专用的 220V~，50 H z，10A带
接地故障断路器或接地漏电保护器的电路中。
220V~，50Hz，10A
Kohler Co.
9
1386539-T01-B

垫圈， 卡在
垫片 垫片近孔
垫圈内，注意垫片方向：垫片近孔弯折处向上。
螺钉
垫片
垫片
垫片
垫片。
1386539-T01-B
10
Kohler Co.