Lanner electronics EM-561 Series User manual

EM-561 SERIES
5.25” EMBEDDED SBC
WITH VGA &THREE 10/100MBPS LAN
FOR SOCKET370 PENTIUM III PROCESSOR
USER'S MANUAL

COPYRIGHT ©
This document is a copyright of the original manufacturer, 2001. The original manufacturer
reserves the rightsto make improvement and/or modification to the product described in this
manual at any time without further notice. This manual may not, in whole or in part, be
photocopied, reproduced, transcribed, translated, or transmitted in whatever form without the
written consent of the manufacturer, except for copies retained by the purchaser for backup
purposes. All rights are reserved.
TRADEMARKS
The following are trademarks or registered trademarks of their respective companies: IBM, Intel,
AMD, Cyrix, NS, Award, AMI, Microsoft, Windows, Windows NT, Novell, SCO, PC/104, PICMG, ALI,
UMC, SMC and Winbond. Products mentioned in this manual are mentioned for identification
purposes only. All names of products or services appearing in this manual are the trademarks or
registered trademarks of their respective organizations and companies.
ãCopyright 2001
Date: October 1st , 2001

TABLE OF CONTENTS
CHAPTER 1General Information …………………………………………..…… 1
1.1Introduction ………………………………………………………………….……….. 1
1.2Features ………………………………………………………………………..……….. 1
1.3 Specification ………………………………………………………………….……….. 2
1.4 Unpack Your EM-561 ………………………………………………………..…… 2
1.5 Board Layout …………………………………………………………………..……….. 3
CHAPTER 2Installation …………………………………………………………….4
2.1 Hardware Setup and Installation ………………………..…………………… 4
2.1.1 CPU Installation and Upgrading ……………….…………………… 4
2.1.2 System Memory Installation ………………………………………… 5
2.1.3 DiskOnChip Installation ………………………..…………………….. 6
2.2 Jumper Settings And Connectors ……………………………………………….6
2.2.1 Board Outline …………………………………………………….……… 6
2.2.2 Jumper Settings Summary ………………………………..………….7
2.2.3 I/O Connectors Summary ……………………………..……………… 10
CHAPTER 3BIOS Setup ………………………………………………………… 26
3.1 Running Award BIOS……………………………………………………………….26
3.2 CMOS Setup Utility ………………………………………………………………….27
3.3 Standard CMOS Setup ……………………………………………………………… 28
3.4 BIOS Features Setup ……………………………………………………………….. 30
3.5 Chipset Features Setup …………………………………………………………….32
3.6 Integrated Peripherals …………………………………………………………….. 34
3.7 Power Management Setup ……………………………………………………….36
3.8 PnP/PCI Configuration ……………………………………………………………… 39
3.9 PC Health Status ……………………………………………………………………….40
3.10 Frequency / Voltage Control ……………………………………………………. 41
3.11 Load Fail-Safe Defaults …………………………………………………………….. 42
3.12 Load Optimized Defaults …………………………………………………………… 42
3.13 Supervisor / User Password …………………………………………………….. 43
3.14 Save & Exit Setup …………………………………………………………………….. 43
3.15 Exit Without Saving ………………………………………………………………….. 44
CHAPTER 4Drivers Support ……………………………………………………… 45
4.1 Driver Support …………………………………………………………………………… 45
4.1.1 Core Chip ………………………………………………………………..…….45
4.1.2 Network ……………………………………………………………………… 45
4.1.3 VGA ………………………………………………………………………….. 45
4.1.4 Hardware Monitor ……………………………………………………….46
4.2 Driver List ……………………………………………………………………………….46
4.3 Driver Setup and Installation …………………………………………………….47
4.3.1 Intel 815 Chipset ………………….…………………………….……….47
4.3.2 Intel Ultra ATA Storage Driver ………………..…………………….49
4.3.3 VGA Driver …………………..……………………………………………… 51
4.3.4 LAN Driver …………………….…………………………………………….53
APPENDIX A How To Use Watch-Dog Timer
Terms and Condition
RMA Service Request Form

Page: 1
CHAPTER 1General Information
1.1 Introduction
The new EM-561 Series embedded SBC is highly configurable with multiple features to suit
different types of commercial and industrial needs. Three Ethernet capability of the EM-561 Series
gives network administrators another tool to deal with today's changing application needs. The
board comes with the top-of-the-line Intel 82559 LAN chips could act as a firewall that sits
between the Internet and a company's internal network. This applies to Web (HTTP) servers, FTP
servers, SMTP (E-mail) servers or DNS servers. The EM-561 can also be used as an inter-network
gateway that connects a number of local networks. Once again, the three Ethernet capability and
processing power of the EM-561 Series gives it the ability to perform these functions.
The new EM-561 Series is enhanced with IntelÒ815E chipset; one 168-DIMM socket support up
to 100/133 MHz SDRAM and one DiskOnChip from M-System socket support up to 288MB flash
memory disk which provide full functionality and performance to be used "exactly" where you
need it as well. EM-561 also features high performance VGA display that support resolutions and
color depths up to 1600x1200 x256 color at 85Hz.
EM-561 has many expansion function such as one PCI expansion connector with one PCI riser
card; one FDD interface support up to two floppy devices ; two IDE ports that support up to four
IDE devices and Ultra ATA/100/66/33 interface helps designers and integrators improve system
performance by retrieving and sending data faster. Everything you could need is on-board.
In addition, it is equipped with two RS-232 serial ports; four USB ports; one multi-mode parallel
port which supports SPP, ECP and EPP modes. It provides more flexible functions to satisfy all
users' different application requirements.
The EM-561 also offers several industrial features such as a 16 -level watchdog time-out intervals
and contains the health monitoring hardware. The health monitoring IC keeps an eye on the
CPU and releases an audio alarm when detecting abnormal operating voltage & temperature or
malfunction of the cooling fans. And with its industrial grade reliability, the EM-561 can operate
continuously at temperatures up to 60° C (140° F). All these numerous features provide an ideal
price/performance solution for commercial and industrial applications where stability and reliability
are essential.
1.2 Features
nSupportsSocket 370 Celeron/Intel®Pentium III Processor, 133MHz FSB
nIntel®815E chipset
nBuilt–in three 10/100BASE-TX Ports with RJ-45 connectors
nSocket for DiskOnChip
nWith one PCI expansion slot
n4 USB ports and supports 4 Ultra ATA 100 devices
n5.25” Form Factor, special design for firewall and network applications

Page: 2
1.3 Specification
EM-561 Series
Processor IntelÒPentium III Coppermine / CeleronÔProcessor in Socket
370(66/100/133 MHz) and up to 1GB
Chipset IntelÒ815E chipset
System Memory / RAM One 168-pin DIMM sockets, support 100/133 MHz SDRAM and up to
512 SDRAM
BIOS AwardÒlicensed BIOS
Flash Memory Disk Reserved socket for DiskOnChip from M-System, support up to 288 MB
flash memory disk
Graphics Controller Internal graphic controller with Intel’s Dynamic Video Memory
Technology, resolution up to 1600 x 1200 x 256 colors @ 85 Hz, with
VGA 2x6x2.54 mm pin header with housing
Network Interface Three Intel 82559 chip, support three-10/100 Base-TX Ethernet, three
RJ-45 external connectors with ACT LED, LNK LED
IDE Drive Interface Two PCI IDE ports that support up to four IDE devices and Ultra
ATA/100/66/33
Floppy Drive Interface One FDD port, support up to two floppy devices
Serial Port Two COM ports, one RS-232 DB-9 connector and one RS-232
2x5x2.54 mm pin header with housing
Parallel Port One multi-mode parallel port ( SPP / EPP / ECP )
Bus Interface PCI bus slot
RTC Internal RTC with Li battery
Keyboard/Mouse 6-pin keyboard/mouse pin header
Watchdog Timer 16-level time-out intervals
Universal Serial Bus Support 4 USB ports (4x5 pin headers)
Health Monitoring Enhanced hardware monitor functions with optical sensor
Operating Temperature 0 °C~60 °C
Storage Temperature -20 °C~70 °C
Humidity 5 %~95%RH, non-condensing
Dimensions 203 x 146 x 25 mm ±0.5 mm
EMI/EMS EN 50081-1/1994>EN 55022/1997>EN 61000-3-2/1995
>EN 61000-3-3/1995, EN 50082-1/1994>IEC 1000-4-2/1995,
IEC 1000-4-3/1995, IEC 1000-4-4/1995, EN55024
Remark PCI Rev. 2.2 compliant
ORDERING INFORMATION EM-561B
EM-561C (Customer model No.)
1.4 Unpack your EM-561
Before you begin to install your card, please make sure that you received the following materials as
listed below:
nEM-561 x 1 pc 5.25" Embedded Single Board Computer
nFDD Cable x 1 pc 34 to 34-pin Standard Header Flat Ribbon Cable
nIDE Cable x 1 pc 40-pin IDE Cable
nVGA Cable x 1 pc 12-pin Standard Header to 15-pin/3-Row D-Sub Cable
nKeyboard and Mouse Cable x 1 set 8-pin connector to PS/2 Keyboard and Mouse Cable
nDriver Utility CD-ROM x 1 pc Drivers & Utilities
nUser's Manual x 1 pc This User's Manual

Page: 3
1.5 Board Layout

Page: 4
CHAPTER 2 Installation
2.1 Hardware Setup and Installation
2.1.1 CPU Installation and Upgrading
Step 1: Locate the ZIF socket and open it by first pulling the lever of socket upward.
Step 2: Insert the CPU into the socket. Please keep the lever right angle when
inserting CPU.
Step 3: When inserting the CPU please note the correct orientation as shown. The
notched corner should point toward the end of the lever.
Step 4: Push the lever down to close the socket.
PGA370

Page: 5
Step 5: Attach the heatsink onto the CPU.
Step 6: Push the clip of heatsink downward to hock the ear of socket firmly.
Step 7: Finally, attach the fan cable to the CPU fan header.
2.1.2 System Memory Installation
Step 1: Open latches of DIMM socket.
Step 2: Insert the RAM module into the DIMM socket.
Step 3: Press the latches into the notches of the RAM module.

Page: 6
2.1.3 DiskOnChip Installation
Please make sure the central polarization key on the socket, and place the DiskOnChip
as the same direction.
2.2 JUMPER SETTINGS AND CONNECTORS
2.2.1 Board Outline
CON2
PWR1
IDE1
IDE2
FDC1
Cyrix
COM1
JP5
MS
LAN1
LAN2
LAN3
CON1
JP3 JP2 JP1
JP12
JP15
ATXC1
JP13
JP14
JP6
SDOC1
PCI1
KM1
JP8
DIMI
JP10
JP11
SR1
ATXPS1
Cyrix
Cyrix
CPU
USB1
USB2
USB3
USB4
JP7
ATXPB1
JP9
LPT1
COM2
VGA1
FAN1
AT Power Connector 90
。
forEM-561C
PS1