LEGRAND 7 521 90 User manual

LE10668AA
This pack is a connected accessory which requires you to buy and install the Valena Life
with Netatmo connected starter pack first.
Finishing plate
Site protectionConnected roller shutter
switch
Pack contents
Characteristics
100-240VAC
50/60Hz
1x2,5mm
2x1,5mm
240VAC max. 1x500VA
100VAC max. 1x270VA
+45°C
+5°C
Roller shutter motor
Connected roller shutter switch
7 521 90 - 7 522 90 - 7 523 90
2
Before you start
If you plan to install roller shutter switches, read the following precautions:
To control a roller shutter switch with two or more wireless switches,
only use the products:
To create a centralised control:
- Use one or more connected roller shutter switches.
- Use a roller shutters wireless switch.
x 1 x 1
or several
Connected roller shutter switch Roller shutters wireless switch
(not included in this pack)
Ensure you have roller shutters wireless switches for each additional control point.
AND

3
Necessary safety precautions
Install the connected roller shutter switch
OFF
Switch off the power at the main circuit breaker
Wire the connected roller shutter switch
Remove the existing switch
Frequency bands: 2.4 - 2.4835 GHz
Power level: <100mW
The Valena Life with
Netatmo solution
is compatible with
roller shutters with
a mechanical or
electronic stop,
controlled by a
standard wired roller
shutter switch. They
are not compatible
with motors directly
controlled by radio control. To check it,
refer to the roller shutter instructions.
Make sure that the power
is off before continuing
with the installation.
N (neutral) = blue
L (live) = any except blue and green/
yellow
(earth) = green/yellow
Safety instructions
This product should be installed in compliance with installation rules, preferably by a qualified electrician. Incorrect installation
and/or incorrect use can lead to risk of electric shock or fire. Before carrying out the installation, read the instructions and take
account of the product’s specific mounting location. Do not open up, dismantle, alter or modify the device except where
specifically required to do so by the instructions. All Legrand products must be opened and repaired exclusively by personnel
trained and approved by Legrand. Any unauthorised opening or repair completely cancels all liabilities and the rights to
replacement and guarantees. Use only Legrand brand accessories.
To add a connected product to your connected installation,
you should follow the instructions:
- in the user guide in your connected starter pack
- in the Legrand Home + Control application (Settings/Add a new product section)
- or consult the user manual on legrand.fr
www.legrand.fr
LEGRAND - Pro and Consumer Service - BP 30076
87002 LIMOGES CEDEX FRANCE • www.legrand.com
SIMPLIFIED EU DECLARATION OF CONFORMITY
The undersigned,
Legrand
declares that the radio-electric equipment referred to in these
instructions complies with directive 2014/53/EU.
The full text of the EU declaration of conformity
is available on the following website :
www.legrandoc.com