9
Adding Your Outlet To A Hub
Leviton Decora SmartTM Z-Wave® devices support two methods of inclusion.
When using a Z-Wave Plus certied controller choose Network Wide Inclusion
or SmartStart. If network wide Inclusion does not discover your device, please
try classic inclusion.
Network Wide Inclusion To A Z-Wave Network
Modern Z-Wave Plus hubs support network wide inclusion which allows
your device to be included into the network using devices already paired
to your home automation hub. Work your way from the devices closest
to the hub outward.
1. To enter programming mode, hold the button for 7 seconds. The
status light will turn amber.
2. Tap the button 1 time. The status light will quickly ash green.
3. The outlet is now ready to learn into the Z-Wave network. Follow
directions for the Z-Wave controller to complete the process.
4. Upon successful addition to network the status light will turn o
and then ash green 4 times. If it was not successfully added to
the network, the status light will ash red 4 times.
Classic Inclusion To A Z-Wave Network
For older controllers Classic Inclusion is supported. Depending on the
age of the controller the controller will need to be 3 to 35 feet from the
device when including.
1. To enter programming mode, hold the button for 7 seconds. The
status light will turn amber, release and the status light will blink.
2. Follow the Z-Wave controller instructions to enter exclusion mode.
3. Tap the top of the button one time. The status light will quickly
ash green.
4. The Z-Wave controller will conrm successful inclusion in the network.
