9.7 Operation on the platform
1) Engage the ignition switch on the platform controls.
2) Place the red emergency stop buttons on the platform control and the ground control in the "ON" position.
3) Keep the battery pack properly connected before the machine runs.
9.8 Adjusting platform position
1) Press the lift function selection button.
2) Press the dead man switch on the control lever.
3) Move the lever according to the sign on the control panel.
9.9 Turning
1) Press the drive function select button.
2) Press the dead man switch on the control lever.
3) Turn the steering wheel via the toggle switch at the top of the steering lever.
9.10 Driving
1) Press the drive function select button.
2) Press and hold the on/off button on the control lever.
3) Accelerate: move the control lever slowly from the centre.
Slow down: Slowly move the control lever to the centre.
Stop: Move the control lever back to the centre or release the on/off button.
4) Determine the direction of travel with the directional arrows on the platform steering and chassis.
5) When the platform is raised from the transport status, the speed of movement is limited.
6) The status of the battery affects machine performance.
7) When the battery level indicator light flashes, the machine's travel and function speed are reduced.
9.11 Driving speed option
The driving control can be performed at two different speeds. When the light on the driving speed selector lever
illuminates, the low speed mode is engaged. When the light on the driving speed selector switch goes out, the high
speed mode is engaged. Press the driving speed selector to select the desired driving speed.
9.12 Operation with ground control
1) Maintain the safe distance between the operator, machine and the attachment part.
2) Pay attention to the progress direction of the machine when using the controls.
3) Identify the battery level with the LED diagnostic device.
9.13 Use of a safety support
1) Lift the platform to a height of 2,4 m above the ground.
2) Lift the safety support, move it to the centre of the scissors housing and turn it up until it's vertical.
3) Lower the platform height until the safety support is completely against the shaft housing. Keep the
platform away from moving parts in the lowering process.
Danger: do not transport a load on the platform when using the safety support. It won't take long (8 hours)
to use safe arm support in the empty state.