BLTL Linear Task Light Installation Manual
Page 2of 7
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING –It is recommended that installation be
performed by a certified electrician.
•WARNING –All electrical connections must be in compliance
with local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to learn
about your local codes, permits and/or inspections.
•WARNING –DO NOT connect this Luminaire to an electrical
system that does not provide means for equipment
grounding. Never use a fixture in a two-wire system that is
not grounded.
•WARNING –DO NOT use excessive force when manipulating
cables and wires.
•WARNING –To prevent wiring damage or abrasion, DO NOT
pinch wires between surfaces.
•WARNING –Only connect luminaire to 120VAC power
outlet. It is intended for direct connection to this voltage. DO
NOT connect to a different or unknown voltage.
•WARNING –DO NOT modify luminaire, plug, or mounting
hardware.
CONTENTS OF KIT
•BriteCor Linear Task Light
•PKG Mounting Kits (MAG and ARM)
•MAG Magnet Mount Kit Includes:
o(2) magnets
o(2) M6 square nuts
•ARM Mounting Arm Clamp Kit Includes:
o(1) Mounting arm
o(1) ½-20 bolt
o(1) ½-20 threaded spacer (attached to arm)
