LITESHEET BriteCor AC Direct BWA User manual

BWA BriteCor AC
Direct Wraparound
Installation Manual

BWA BriteCor Wraparound Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
Litesheet approved dimmers.
•This unit is not approved for use in ducted ceilings.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
CONTENTS OF KIT
•BWA Wraparound Luminaire
TOOLS AND ADDITIONAL PARTS REQUIRED
•¼” Hex or flat head drive.
Document #: 11-00039
Rev: A
Date: 4/21/2022

LiteSheet Solutions
Page 3of 4
Preparation
1. Turn off power source.
2. Remove luminaire from packaging.
3. Remove lens.
4. Remove knockout from fixture for routing
incoming power.
Installation
1. Align fixture to surface to be mounted to,
taking care to locate electrical access in
the proper location. Insert incoming
power cables through the knockout hole.
2. Affix luminaire to surface using code
approved hardware and mounting
techniques.
3. Carefully remove LED board gear tray,
making sure to not allow the tray to drop
suddenly.
4. Attach green ground wire to green
ground screw.

BWA BriteCor Wraparound Installation Manual
Page 4of 4
5. Pull out the black and white pigtail wires
through the knockout hole.
6. Attach incoming hot wire to black pigtail
wire.
7. Attach incoming neutral wire to white
pigtail wire.
8. IF ZT 0-10VDC DIMMING IS INCLUDED
Connect grey and purple ZT (0-10VDC)
dimming wires to existing incoming
0-10VDC wires.
a. Purple –Positive (+)
b. Grey –Negative (-)
NOTE: Keep AC main power wires away
from the 0-10VDC wires.
9. Reattach the gear tray and lens.
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com