LITESHEET BriteCor AC BAA User manual

BAA BriteCor AC
Direct Area Light
Installation Manual

BAA BriteCor Area Light Installation Manual
Page 2of 7
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
Litesheet approved dimmers.
•This unit is not approved for use in ducted ceilings.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –If Luminaire is rated for retrofitting, do
not connect Luminaire kit to the lamp ballast or the
lamp holders.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
Document #: 11-00048
Rev: A
Date: 4/19/2022

LiteSheet Solutions
Page 3of 7
CONTENTS OF KIT
•BAA Area Light Luminaire
•Mounting Bracket
•Extra #8 screws for attaching access plate
TOOLS AND ADDITIONAL PARTS REQUIRED
•#2 Phillips Screw Driver
•¼” Drive
BAA Area Light
Access Plate

BAA BriteCor Area Light Installation Manual
Page 4of 7
Preparation
1. Turn off power source.
2. Attach the mounting bracket through the
screw holes on the fixture.
3. Attach any other supplemental mounting
hardware as provided.

LiteSheet Solutions
Page 5of 7
Installation
1. Mount the luminaire using the bracket
provided (NOTE: Bracket may be different
than the one pictured.) Route the incoming
line power through the access port.
2. Remove the 2 screws on top of the fixture
shown. Support the access plate on the
opposite end of the fixture to prevent it from
falling once loosened. A bag with 3 additional
screws should also be in the housing for
remounting the access plate.
Access Port
Mounting
Bracket

BAA BriteCor Area Light Installation Manual
Page 6of 7
3. Connect the incoming ground connection to
the green ground screw provided. Connect
the incoming line power to the luminaire
connector provided.
•Black –Line Power (Hot)
•White –Neutral
•Green –Safety Ground
4. Reattach the access plate, using caution not to
pinch wires between surfaces. Tighten the 5
screws in the order shown. Screws may need to
be tightened again as the gasket compresses to
insure an even seal.

LiteSheet Solutions
Page 7of 7
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com