LITESHEET BriteCor AC Direct BFHB G3 User manual

BFHB G3 BriteCor AC
Direct Flat High Bay
Installation Manual

BFHB G3 BriteCor Flat High Bay Installation Manual
Page 2of 7
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation
be performed by a certified electrician.
•All electrical connections must be in compliance
with local codes, ordinances or the national
electrical code (NEC). Contact your municipal
building department to learn about your local
codes, permits and/or inspections.
•Do not connect this Luminaire to an electrical
system that does not provide means for
equipment grounding. Never use a fixture in a
two-wire system that is not grounded.
•If dimming functionality is included, use only
with Litesheet approved dimmers.
•Do not use excessive force when manipulating
cables and wires.
•WARNING –To prevent wiring damage or
abrasion, do not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the
voltage indicated by the Luminaire label. It is
intended for direct connection to this voltage. DO
NOT connect to a different or unknown voltage.
Document #: 11-00052
Rev: -
Date: 5/10/2022

LiteSheet Solutions
Page 3of 7
CONTENTS OF KIT
•BFHB G3 Flat High Bay Luminaire
TOOLS AND ADDITIONAL PARTS REQUIRED
•Drill
•Mounting Hardware (Sold Separately)
Preparation
1. Turn off power to the circuit.
2. Remove fixture and mounting hardware from
packaging.

BFHB G3 BriteCor Flat High Bay Installation Manual
Page 4of 7
Cable Kit Installation
1. Attach aircraft cable to the structural support. Adjust
to the desired height.
2. Attach the luminaire to the aircraft cables through the
holes shown. Adjust each cable until luminaire is level.
3. Wire the fixture following NEC standards.

LiteSheet Solutions
Page 5of 7
Chain Kit Installation
1. Attach chains to the structural support. Adjust to the
desired height. Attach the hooks to the chains.
2. Attach the luminaire to the hooks in the holes shown.
Adjust the chains to level the luminaire.
3. Wire the fixture following NEC standards.

BFHB G3 BriteCor Flat High Bay Installation Manual
Page 6of 7
Stem Mount Installation
1. Install cross bracket onto pre-installed J-box. Attach
wires to existing wiring using NEC approved methods,
and feed through 3/8” IPS stem.
2. Install stem into cross bracket.
3. Remove cover on fixture box. Make electrical
connections from the stem to the fixture wiring
following NEC standards.
4. Reattach box cover.

LiteSheet Solutions
Page 7of 7
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com