LITESHEET BriteCor AC BCF User manual

BCF BriteCor AC
Direct Canopy
Installation Manual

BCF BriteCor Canopy Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
Litesheet approved dimmers.
•This unit is not approved for use in ducted ceilings.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
•Enclosure is rated for Wet Location and IP65. When
installing incoming connections, all wire ports must be
sealed using similar rated hardware to maintain Wet
Location and IP65 rating.
Document #: 11-00036
Rev: B
Date: 4/12/2022

LiteSheet Solutions
Page 3of 4
CONTENTS OF KIT
•BCF LED Luminaire
TOOLS AND ADDITIONAL PARTS REQUIRED
•Mounting screws
•Silicon sealant
•#2 Philips head screw driver
•Flat head screw driver
Preparation
1. Turn off power source.
Installation
1. Open luminaire by removing the lens (4 screws.)
2. Knock out / drill holes in the rear housing for
mounting fixture to wall and for securement to
junction box (j-box not provided.)
3. Apply silicon sealant (not provided) to any
unused holes to prevent water entry.
4. Secure fixture to wall with two or more screws
(not provided).
5. Secure fixture to junction box with screws (not
provided).

BCF BriteCor Canopy Installation Manual
Page 4of 4
Installation (Continued)
6. Connect the incoming ground connection to the
green ground wire provided. Connect the
incoming line power to the luminaire disconnect
provided.
•Black –Line Power (Hot)
•White –Neutral
•Green –Safety Ground
7. Close the luminaire lid and reinsert the machine
screws. Tighten the screws fully to ensure a tight
seal.
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com