LITESHEET BriteCor AC Direct BBS User manual

BBS/BSS BriteCor
AC Direct
Portable Luminaire
Installation Manual

BBS/BSS BriteCor Portable Luminaire Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
Litesheet approved dimmers.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
CONTENTS OF KIT
•LED portable luminaire
OPTIONAL HARDWARE
•(3) Vertical wall mounting brackets
•(2) Plastic toggle drywall anchors
•(2) #8 x 1-1/2 Screws
•(1) Red key
TOOLS AND ADDITIONAL PARTS REQUIRED
•Drill with 5/16” diameter drill bit
•#2 Philips head screwdriver
Document #: 11-00011
Rev: E
Date: 4/12/2022

Page 3of 4
Preparation
1. Turn off power source.
Optional Vertical Mounting
(Installation in Sheet Rock)
1. While holding the 5/8” x 6 ½” aluminum
mounting piece to desired mounting position,
transfer the holes to the drywall. Remove the
mounting piece and drill (2) 5/16” holes.
2. Fold the anchor in the middle and insert
anchor into one hole and tap flush. Insert red
key to pop open the anchor open behind the
wall. DO NOT HAMMER KEY. Remove red
key. Repeat for remaining hole.

BBS/BSS BriteCor Portable Luminaire Installation Manual
Page 4of 4
3. Bend (2) center tabs of each of 2 smaller
mounting pieces to approximately a 45°
angle. Place smaller mounting piece with
dimples toward the wall over the longer
mounting piece with tabs facing up. Line up
holes on the 2 mounting bracket holes over
the anchors. Insert screws and tighten until
flush with the mounting bracket –then stop.
2. Place portable luminaire over mounting
bracket and line up the bent tabs with
rectangle holes on back of the luminaire.