LITESHEET BriteCor AC BDEK User manual

BDEK BriteCor AC
Direct Troffer
Retrofit Installation
Manual

BDEK BriteCor Troffer Retrofit Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be performed by a
certified electrician.
•All electrical connections must be in compliance with local codes,
ordinances or the national electrical code (NEC). Contact your
municipal building department to learn about your local codes,
permits and/or inspections.
•Do not connect this Luminaire to an electrical system that does not
provide means for equipment grounding. Never use a fixture in a
two-wire system that is not grounded.
•If dimming functionality is included, use only with Litesheet
approved dimmers.
•This unit is not approved for use in ducted ceilings.
•Do not use excessive force when manipulating cables and wires.
•WARNING –To prevent wiring damage or abrasion, do not pinch
wires between surfaces.
•WARNING –Luminaire is rated for retrofitting. Do not connect
retrofit kit to the lamp ballast or the lamp holders.
•WARNING –Only connect Luminaire to the voltage indicated by the
Luminaire label. It is intended for direct connection to this voltage.
DO NOT connect to a different or unknown voltage.
CONTENTS OF KIT
•BDEK / BDEKG3 (Endcaps, LED panel, side panel)
•Quarter turns
TOOLS REQUIRED
•Drill/screwdriver
Preparation
1. Turn off power source.
2. Remove existing hardware of any ballast covers,
socket bars, lamps, ballasts and sockets so that only
the pan remains. Dispose of lamps and ballasts as
recommended by the manufacturer.

LiteSheet Solutions
Page 3of 4
Installation
1. Place endcaps between ceiling grid and existing
troffer.
2. Slide LED panel between the grid and the existing
troffer. Fasten with quarter turns. Connect retrofit to
incoming power using NEC approved methods.

BDEK BriteCor Troffer Retrofit Installation Manual
Page 4of 4
3. Insert side panel between grid and troffer. Fasten to
endcaps using quarter turns.
4. Insert lens into the track.
5. Turn on power to the fixture.
Document #: 11-00022
Rev: A
Date: 4/27/2022