LITESHEET BriteCor AC BTS Series User manual

BTS BriteCor AC Direct
Troffer Series
Installation Manual

Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with
local codes, ordinances or the national electrical code
(NEC). Contact your municipal building department to
learn about your local codes, permits and/or
inspections.
•Do not connect this Luminaire to an electrical system
that does not provide means for equipment grounding.
Never use a fixture in a two-wire system that is not
grounded.
•If dimming functionality is included, use only with
LiteSheet approved dimmers.
•Do not use excessive force when manipulating cables
and wires.
•WARNING –To prevent wiring damage or abrasion, do
not pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage
indicated by the Luminaire label. It is intended for
direct connection to this voltage. DO NOT connect to a
different or unknown voltage.
CONTENTS OF KIT
•BTS / BTSG3 Troffer Luminaire
TOOLS AND ADDITIONAL PARTS REQUIRED
•¼” Hex or flat head drive.
Document #: 11-00029
Rev: C
Date: 4/20/2022

Page 3of 4
Preparation
1. Turn off power source.
2. Remove luminaire from packaging.
Installation
1. Place luminaire into recessed ceiling.
Move the fixture to align with grid.
2. Remove access plate from the back of the
luminaire and knock out a hole in the
access plate.
3. Route the incoming wires through the
hole in the knockout
4. Attach green ground wire to green
ground screw on the access plate.
5. Attach incoming hot wire to black wire on
luminaire.
a. Must use 18 AWG or larger wires.
6. Attach incoming neutral wire to white
wire on luminaire.
a. Must use 18 AWG or larger wires.

Page 4of 4
Installation (Cont.)
7. IF ZT 0-10VDC DIMMING IS INCLUDED
Connect grey and purple ZT (0-10VDC)
dimming wires to existing incoming
0-10VDC wires.
a. Purple –Positive (+)
b. Grey –Negative (-)
NOTE: Keep AC main power wires away
from the 0-10VDC wires.
8. Reattach the access plate to the luminaire.
For warranty information and
technical support, contact us at:
434-446-1460
Find more great products at:
www.litesheet.com