Assembly Instructions & Parts List
BEFORE ASSEMBLY PLEASE REMOVE ALL PROTECTIVE FILM FROM LEAVES
1
Remove the top spine cover and place the spine on a
level surface, with the bulb holders facing upwards.
mount holes
3
2
Using 12 of the shorter bolts, nuts and washers,
assemble the 4 side panels together, ensuring that the 2
panels with cutouts are opposite each other.
Place the part built shade onto the spine lining up the
mounting holes. The bulb holders should be coming
through the cutouts in the shade.
feed bolts
through here
45
from shade from ballast
live
earth
neutral
6
Next, line up the space bar with the mounting holes
of the spine and shade, and then do the same with the
top diffuser plate. Pass one of the long bolts through
the top plate, spacer bar, shade and then spine (in that
order). Secure the bolt from inside the spine with a
nut and washer. Do this with all 4 mounting points on
the spine.
Loosen the gland lock nut and feed your ballasts cable
through the gland.
Next, wire your ballast into your shade ensuring that
both lives, both neutrals, and both earths are securely
connected into the correct place on the connector
block. With no stripped cable showing once the wires
are secured.
Live is marked L
Neutral is marked N
Earth is symbolised with
If unsure, please get a qualied electrician to complete
this stage of the assembly process.
open close
7
Bolt the spine cover onto the spine housing with 6
small bolts and washers, and tighten with the cable
gland.
To install the bulb, simply slide the bulb holders to
the outside, insert the bulb, and then close the bulb
holders. Please ensure that the bulb is securely located
before moving the shade.
ENGINEERED BY QWOD
www.Lumatek.co.uk
Spine Assembly x1
Top Diffuser Plate
Side Panels x4 (2 Feature Cutout)
Fixings Bag
Space Bar x2
A
B
C
D
E
Pro DE Reflector
ENGINEERED BY QWOD
AB
C
D
E
