M-LOCKS EuroLine Compact series User manual

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: [phone]
NL-7005 BN Doetinchem 1 www.m-locks.com
Technical manual
KL1560
CHARACTERISTICS
The EuroLine Compact series was specially developed for safes which have two through
holes, 100mm apart. The plastic housing of the EuroLine unit combines a front reading dial
with a large boltwork handle (metal). The set includes a 6mm square shaft for usage with
lock ML6740 as well as an 8x8mm square shaft to drive the boltwork. The pictures show the
most common usage but the unit can be fitted mirrored and also vertical.
PREPARATION
1. Mechanical Dial
Measure the distance (D) between the mounting surfaces of the dial and the lock (see picture
below). Cut the shaft in one of the eight provided grooves. Use the table below to determine
in which groove to cut. Do not leave more segments on the shaft than necessary. Normally
no de-burring is required.
Affix the 6mm shaft with the provided screw in the dial and cover the screw with the small
label. Discard the larger label.
Distance (D)
less than Cut groove #
28
mm
1.1 inch 1
40 mm
1.6 inch 2
53 mm
2.1 inch 3
66 mm
2.6 inch 4
78 mm
3.1 inch 5
91 mm
3.6 inch 6
104 mm
4.1 inch 7
116 mm
4.6 inch 8

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: [phone]
NL-7005 BN Doetinchem 2 www.m-locks.com
2. Handle
Cut the 8mm square shaft to an appropriate length. The shaft should stick out of the boltwork
5-8mm and will be secured by the star washer. Assemble the handle as shown below. Affix
the shaft in the handle with the provided screw and cover the screw with the label.
The spindle hole should be Ø: 11-13 mm.
Star Washer
DIMENSIONS:

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: [phone]
NL-7005 BN Doetinchem 3 www.m-locks.com
Adjust position and mount the housing with 3x M4 or 8/32” flathead, countersunk screws (not
included). Push the 8x8mm (handle) shaft as shown above into the boltwork.
Lock and boltwork must be in the “OPEN” position. Fit star washer on shaft from inside
to lock in position.
Install the ML6740 lock first according to the installation instruction and make sure it is in the
open position.
With the lock in OPEN position (bolt retracted) hold the dial in a
way that approximately “93” is lined up with the opening index
and push it into the lock.
The shaft cannot be pulled out.