M-LOCKS T6530 User manual

T6530
M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.2 2011 10 21 Fax: [phone]
NL-7005 BN Doetinchem 1 www.m-locks.com
Technical manual
Mounting Instructions
T6530 with blue foil keys
T6530 DL with Dallas reader and blue foil keys
T6530 B with black foil keys
T6530 DLB with Dallas reader and black foil keys
Optional for use with Straightbolt locks:
T9090 turnable backplate
DIMENSIONS
The terminal for the electronic key (Dallas Key) is located in the front, over the keypad (only models
T6530 DL and T6530 DLB).
Fixing of the input pad: 1 Stationary
2 Turnable
1. STATIONARY MOUNTING
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must be
deburred well to avoid damage to the cable.
- Lift the pad so that you can see mounting holes.
- Let lock’s connecting cable pass through the hole on safe’s door.
- Insert and fix the two inbus screws, paying attention to cables, they have not to be squashed
by housing and let battery cables have easy access.
- Drill (3,5 mm) the screw heads so that tools don’t work for dismounting (due to EN1300)
Clean the keypad surface.
Remove adhesive film from pad and line up margins carefully, before fixing it.

T6530
M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.2 2011 10 21 Fax: [phone]
NL-7005 BN Doetinchem 2 www.m-locks.com
2. TURNABLE ENTRY UNIT only with T9090
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must be
deburred well to avoid damage to the cable.
Connect the cable to the lock at the “ENT” position and mount the lock.
Connect one (1) battery to the battery clip. Only use 9V ALKALINE Duracell Procell- or Energizer
batteries.
Prepare the mounting and cable holes according to picture
- Hold the bearing plate in a way against the mounting
surface that “UP” is readable on top.
-
Affix the plate with the two mounting adapter screws (M4),
hand tied.
- Drill (3,5 mm) the
screw heads so that tools don’t work for
dismounting (due to EN1300)
Insert first the spring and pin into the hole on the back cover
Insert the grooved shaft all the way into the entry housing
Route the cable through the cable hole
Hold the unit at the (approximately) 10:00 o’clock position and
slide it on the mounting adapters.
Turn unit clockwise until it clicks into a
stationary position at 12:00.
Remove adhesive film from pad and line
up margins carefully, before fixing it.