M-LOCKS EuroLine MODULAR Series User manual

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.1 2010 07 14 Fax: [phone]
NL-7005 BN Doetinchem 1 www.m-locks.com
MODULAR
Technical Manual
Mounting Instructions
ST4005, ST4010, ST4015 (flush)
CHARACTERISTICS
The protrusion of the EuroLine “Modular“ series is very low because the battery box is
located inside the safe. It is available in mat chrome (ST4005) or black plastic housing
(ST4010, ST4015). ST4015 further reduces the protrusion as it is recessed and almost flush
with the door surface. Cable length is approximately 35cm.
DIMENSIONS / MOUNTING INSTRUCTIONS
The diameter of the cable hole should be minimum 9mm, maximum 12mm. De-burr the cable
hole well to avoid damage.
ST4005, mat chrome, ST4010 black
ST4005 ST4015ST4010

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.1 2010 07 14 Fax: [phone]
NL-7005 BN Doetinchem 2 www.m-locks.com
ST4015 (flush) black
Mount the housing with two M4 flathead screws (not included). Keep the inside of the
housing clean (remove dust). Route the cable through the cable hole.
Route the battery cable in the opposite direction through the cable hole and push the white
connector into the receptacle on the circuit board. Make sure the connector is completely
seated.
Remove the protective layer from the adhesive ring on the back of the keypad unit. Position
the keypad and press it into the housing. Make sure the surfaces are dry and clean, and
no cables are in the way. Do not remove and re-apply keypad once it has been glued
in the housing!
Connect one battery to the battery box. Only use 9V ALKALINE Duracell Procell or
Energizer batteries.
These mounting instructions are part of the VdS approval and should be followed strictly.