M-LOCKS RotoBolt User manual

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: [phone]
NL-7005 BN Doetinchem 1 of 2 www.m-locks.com
Technical Manual
Mounting Instructions
EM2050
CHARACTERISTICS
The RotoBolt lock can be mounted in all four mounting directions. Also, by flipping the lock, all
blocking directions can be achieved. The mounting dimensions are standard. The lock is
delivered with metric (M6) mounting screws.
The electronics feature a 6-digit main code that can be changed by the user. With the main code
a secondary code can be activated and deleted. If a valid code has been entered, the lock
electronics removes the blocking for 3 seconds and the boltwork can be moved into OPEN
position by pushing the bolt inside the lock case. When moving the boltwork into LOCKED
position the RotoBolt automatically secures.
BOLTWORK REQUIREMENTS and MOUNTING INSTRUCTION
The maximum allowed cable/spindle-hole diameter is 11mm (if located under the lock body)
If the RotoBolt lock is used in conjunction with another lock, the boltwork must be constructed in a
way that the RotoBolt secures first.
In the LOCKED position the distance between the RotoBolt bolt
and the boltwork part that is moving the lock bolt should be
approximately 1 mm.
Only use NL LOCK supplied screws to mount the lock. Tighten the
screws securely so the lock body is attached firmly to the
mounting surface.
(Maximum Torx 5, 5 Nm)
Mount the entry unit following the
manufacturer’s instruction.
Insert the connector of the entry unit in
the outer (ENT) position. Connect
battery/alarm box connector (if used) in
the inner (BAT) position. Check that the
connector(s) is completely seated. To
remove the connector(s), carefully lift and
pull it out.
In the entry unit or battery/alarm-box,
connect a 9V Duracell Procell Alkaline or
Energizer battery.
Tie cables away from moving parts.

M-LOCKS BV Tel: [phone]
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: [phone]
NL-7005 BN Doetinchem 2 of 2 www.m-locks.com
Mechanics
Opening Half automatic
Locking Automatic
Blocking element Motor cam
Mounting dimensions standard
Electronics
Power supply 9V Duracell Procell ALKALINE or Energizer battery
Software
Codes Up to 10
Primary code 1
Secondary code Up to 9
Time delay/open window 01-99/01-19 min
Battery low signal yes
Manipulation protection 5 minute lockout after 4 consecutive wrong codes
Certifications
VdS M107305 Klasse 2
EN 1300 Class B
UL Type 1
DNV
CNPP & IMP Pending
FUNCTIONAL TEST (with door open) Lock in factory mode
• Enter code (5,5,5,5,5,5). The lock emits a double signal for the correct code.
• Turn boltwork handle towards OPEN position.
The bolt rotates into the housing. Bolt must move freely.
• Turn handle towards Locked position.
The lock bolt must fully extend and secure.
• Make sure there is an air space on all sides of the lock bolt when the safe’s boltwork is
fully thrown into locked position.
Repeat functional test several times before locking the safe door.
DATA SHEET