Mainstays MS18-D2-1011-01 User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2018-05-08 Rev. 0001-B Factory: CHEGRE
Arris Writing Desk
Stock # MS18-D2-1011-01
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the store
where it was purchased. Please call our customer service number and have your instructions and parts list
ready to provide the model name, part name or factory number:
866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenstyle.com
Or e-mail your request to [e-mail]
LOT NUMBER:
DATE PURCHASED: / /

2
MANUFACTURER: Whalen Furniture Manufacturing
CATALOG: Arris Writing Desk
MODEL # MS18-D2-1011-01
MADE IN CHINA
1. Please read the Assembly Instructions prior to assembling the unit.
2. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
3. Keep all hardware part out of reach of children.
4. Please wait until all steps are completed before tightening bolts.
5. Make sure all bolts are tightly fastened before the unit is used.
MAXIMUM LOAD 200 lb. (90.8 kg)
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE
MAXIMUM WEIGHTS INDICATED. USE WITH HEAVIER THAN THE MAXIMUM
WEIGHTS INDICATED MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.
GENERAL INFORMATION, TIPS AND TRICKS

3
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Desk Top (Qty. 1)
B- Left Side Frame (Qty. 1) C- Right Side Frame (Qty. 1)
D- Bottom Stretcher (Qty. 1) E- Metal Bar (Qty. 2)
(1) 5/8” Bolt (Qty. 8+1 extra) (2) 2 1/4” Bolt (Qty. 4+1 extra)
(3) Lock Washer (Qty. 4+1 extra) (4) Flat Washer (Qty. 4+1 extra)
Hex Wrench (Qty. 1) Touch-up Pen (Qty. 1)
Tools required: Hex wrench (provided).

4
Assembly Instructions
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Position the Desk Top (A) upside down on a level and protected surface as shown.
3. Attach the Left Side Frame (B) to the Desk Top (A) with two 2 1/4” Bolts (2) and two Washers (3 and 4).
4. Attach the Bottom Stretcher (D) to the Left Side Frame (B) with two 5/8” Bolts (1).
5. Repeat the same procedure to attach the Right Side Frame (C) at the opposite side.
B/C
B/C
1
1
D
D
Lock Washer
(4 used in this step)
③
5/8” Bolt
(4 used in this step)
①
Flat Washer
(4 used in this step)
④
2 1/4” Bolt
(4 used in this step)
②

5
Assembly Instructions
6. Stand the unit upright and position at the desired location.
7. Attach two Metal Bars (E) between the Desk Top (A) and the Bottom Stretcher (D) with four 5/8” Bolts
(1).
E
A1
D
1
EE
A
5/8” Bolt
(4 used in this step)
①

6
Assembly Instructions
8. If necessary, adjust the pre-attached floor levelers at the bottom of Side Frames (B and C) to level the
unit.
B

7
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Always use coasters under beverage glasses and flowerpots.
Liquid spills should be removed immediately. Using a soft, clean cloth, blot the spill gently. Avoid rubbing.
Always use protective pads under hot dishes and plates. Heat can cause chemical changes that may create
spotting within the furniture finish.
In the event that your furniture is stained or otherwise damaged during use, we recommend that you call a
professional to repair your furniture.
Check bolts/screws periodically and tighten them if necessary.
Further Advice about Furniture Care
It is best to keep your furniture in a climate-controlled environment. Extreme temperature and humidity
changes can cause fading, warping, shrinking and splitting of wood. It is advised to keep furniture away from
direct sunlight as sun may damage the finish.
Proper care and cleaning at home will extend the life of your purchase. Follow these important and helpful tips
that will enhance your furniture as it ages.
A touch-up pen has been provided to minimize the small nicks or scratches that may occur during
assembly or shipping.
We hope you enjoy your purchase for many years.
Thank you for your purchase!
QUALITY GUARANTEE
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will repair
or replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is
designed to meet your highest expectations. We guarantee that you will immediately see the value of
our fine furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from
State to State.
Customer Service: 866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
www.whalenstyle.com

ESTE INSTRUCTIVO CONTIENE INFORMACION IMPORTANTE DE SEGURIDAD.
POR FAVOR LEA Y MANTENGA PARA USO FUTURO.
Fecha 2018-05-08 Rev. 0001-B Fábrica : CHEGRE
Escritorio Arris
Serie # MS18-D2-1011-01
ENSAMBLE REQUERIDO POR ADULTO
Si tienen alguna pregunta acerca del ensamble o si alguna parte está faltante, no retorne esté producto
a la tienda donde lo compró. Por favor llame a nuestro departamento de ayuda al cliente teniendo su
instructivo y lista de partes para proveer el modelo, nombre de parte o el número de fábrica :
866-942-5362
Hora estándar del Pacífico: 8:30 a.m. - 4:30 p.m., de Lunes a Viernes
O visite nuestra página de Internet 24 horas al día, 7 días a la semana para asistencia
www.whalenstyle.com
O mande un correo electrónico a [e-mail]
NÚMERO de LOTE:
FECHA de COMPRA: / /

2
FABRICANTE: Whalen Furniture Manufacturing
CATALOGO: Escritorio Arris
MODELO # MS18-D2-1011-01
HECHO EN CHINA
1. Por favor lea el instructivo antes de comenzar el ensamble .
2. Para evitar daños, ensamblar el producto en una superficie fuerte, nivelada y libre de abrasivos .
3. Mantenga todo el material de ferretería fuera del alcance de niños.
4. Esperar hasta que todos los pasos estén completados antes de apretar los pernos.
5. Asegurar de que los pernos estén apretados antes de usar la unidad .
CARGA MÁXIMA 200 lb. (90.8 kg)
MÁXIMO PESO RECOMENDADO
ESTA UNIDAD DEBE UTILIZARSE CON LOS PESOS MÁXIMOS
INDICADOS. SI SE EXCEDE EL PESO MÁXIMO, PODRIA RESULTAR EN UNA
INESTABILIDAD DE LA UNIDAD CAUSANDO POSIBLES LESIONES.
INFORMACIÓN GENERAL, RECOMENDACIONES Y TRUCOS