Matsing MS-8H120 User manual

TABLE OF CONTENTS:
BEAMS & CONNECTORS:
Plan View Resultant Beam Direction
Plan View Connector Layout
Connector Ports Table
PATTERN DIAGRAM
Horizontal Beam Pattern
Vertical Beam Pattern
TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
Installation using a crane
Lifting the Antenna
Antenna Installation
Antenna Leveling
Digital Level Gauge Calibration
Adjustment Requirement
Revision History:
[email protected] www.matsing.com 1 / 6
3.40
3.41
3.42
3.43
2.20
3.00
3.10
3.20
3.30
3.31
1.00
1.10
1.20
1.30
2.00
2.10
email:
website:
Page
Revised by
Revision
nos.
Date
Description
Pavel
MS-8H-120-IM-001
0
INSTRUCTION MANUAL MS-8H120
MS-8H120
Instruction Manual
Date
Prepared by
Approved by
Document nos
Revision
7 Jul 2023
Ray Ling

BEAMS & CONNECTORS:
Plan View Resultant Beam Direction
Plan View Connector Layout
Connector Ports Table
2 / 6
1.30
Page
1.00
1.10
1.20

Frequency: 1695 MHz
Plan View Resultant Beam Directions
PLAN VIEW CONNECTOR LAYOUT
MS-8H120

PATTERN DIAGRAM
Horizontal Beam Pattern
Vertical Beam Pattern
3 / 6
Page
2.20
2.00
2.10

MS-8H120
Frequency:
1695 - 2690 MHz



MS-8H120
Frequency:
1695 - 2690 MHz

TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
4 / 6
1
120cm
Ø13mm x 8
4
M12 x 20cm = 8 Sets
Page
3.00
3.10
3.20
Item
Lens Size
Holes Size
Bracket Qty
Bolt & Nuts Sets
Strictly comply to the Local authority and regulatory on Workplace Safety and Health Control and
Measure when moving and transportation of large or heavy equipment, appropriate material handling
machine should be use.
(Risk Assessment apply for Forklift or Pallet Truck Lifting)
Attached the
bracket tighten
with specified
bolts sets.
Important
Notes:
End User is
require to
Custom-Make
the additional
supporting
bracket and
tighten to the
existing Antenna
bracket to meet
the deployment
needs.

Installation using a crane
Lifting the Antenna
5 / 6
3.30
Strictly comply to the local authority and regulatory on Workplace Safety and Health Control and
Measure when performing lifting of large or heavy equipment, appropriate material handling machine
should be used and only certified personnel should perform the task.
(Risk Assessment requirement applies for both Up-Lifting and Down-Lifting.)
Page
3.31
The antenna has 2 hook points installed on the top frame (located slightly behind the center of the
sphere). These hooks are designed at the center of gravity point of the antenna. A cable, rope can
be securely fastened to the hooks and the antenna can be lifted using a crane as pictured below.

Antenna Installation
Antenna Leveling
Digital Level Gauge Calibration
Adjustment Requirement
6 / 6
Page
3.40
3.41
3.42
With reference to Item 3.2 Bracket Mounting Procedure, End user is required to Custom-Make
the additional supporting bracket and tighten it to the existing Antenna bracket to meet the
deployment needs.
After the Antenna is mounted to the bracket, it is required to be adjusted to 0

3.43