Merrithew SPX Reformers User manual

How to…
Replace Wooden Standing Platform
Removal
Professional Rehab, V2 Max,
Rack & Roll and Client Reformers
1. Remove eight (8) nylock nuts (four
per side) positioned underneath the
wooden standing platform behind
the aluminum rails.
2. Remove eight (8) washers (four
per side) off of the bracket
holding bolts.
3. Slide the support bracket off
the eight (8) bolts.
Steps 1 to 3
Steps 4 to 6 Replacement
4. Position replacement bracket with
wooden standing platform onto
the eight (8) bolts.
5. Reattach all eight (8) washers and
nylock nuts.
6. Ensure that all nuts are tightened.
NYLOCK NUTS AND WASHERS
NYLOCK NUTS AND WASHERS

SPX Reformers
1. Remove the seven (7) screws
from underneath the platform
attach it to the front support
end of the Reformer.
2. Position the new wooden
standing platform onto the front
support end aligning the seven (7)
pilot holes on its underside with
the seven (7) screw holes in the
frame of the front support end.
3. Insert and tighten all screws.
PM-0004G ™/® Trademark or registered trademark of Merrithew Corporation, used under license. All rights reserved.
Step 1
Step 2
Step 3
For more information contact our Customer Service
1.800.910.0001 ext. 0907 | 0800.328.5676 ext. 0907 (UK)
416.482.4050 ext. 0907 (Customer Care)
[email protected]
merrithew.com