METHVEN KIRI SATINJET 13-7602 User manual

July 2012
97-9536
13-7602
SATINJET WALL/CEILING DRENCHER
INSTALLATION GUIDE
13-7701
13-7503
OSQ230CPAU

Slide chrome trim ring onto the appropriate end of
the arm. Screw the arm onto the ½" connection
using plumbers tape or similar to ensure a reliable
seal.
Position the arm vertically and push trim ring into
place.
Remove the protective cap from the showerhead ball
joint and screw the unit onto the wall/ceiling arm
ensuring the filter washer is in place.
1. 3.
Tilt and rotate the shower head to the desired position.
Clean filter washer
periodically.
Water may contain lime which remains on the surface
after the water has evaporated. These lime deposits
can be prevented from forming by wiping
immediately after use.
To clean the chrome-plated surfaces use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
CLEANING
Do not use any
sharp objects to
clean nozzles
Trim Ring Arm
Vertical
Filter Washer
NOTE - If assembling a showerhead to a pre-existing arm skip to step 3
Ball Joint
FOR WALL ARM - RECOMMENDED MINIMUM HEIGHT
2100mm FROM FLOOR LEVEL
2.
4.
Wall
For ceiling instruction follow
same procedures.