Metra Electronics 99-7330 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-7330
99-7330
KIT FEATURES
•Recessed DIN Mount
Radio Provision with Pocket
•ISO Mount Radio Provision with Pocket
A) Radio Housing B) ISO Brackets C) Trim Plate
KIT COMPONENTS
A
Small Flat Blade Screwdriver/ Panel Removal Tool
•Phillips Screwdriver
1-800-221-0932
©COPYRIGHT 2007-2009 METRA ELECTRONICS CORPORATION
www.metraonline.com
TOOLS REQUIRED:
APPLICATIONS
KIA Spectra/Spectra 5
2007-2009
BC
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
•70-1004 - Hyundai 2006-up/KIA harness 2004-up
Antenna Adapter:
•Not required

Dash Disassembly
-KIASpectra/Spectra52007-2009...................................1
Kit Assembly
-DIN Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
-ISO Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Final Assembly ..........................................4
TABLE OF CONTENTS
99-7330
*Note:
Refer also to the instructions included with the aftermarket radio.
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skills
by enrolling inthe most recognized andrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 formore information
and take stepstoward abetter tomorrow.

99-7330 DASH DISASSEMBLY
KIA SPECTRA/SPECTRA 5 2007-2009
A
B
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the trim panel sur-
rounding the radio and including the
a/c vents. (Figure A)
2
Remove (4) Phillips screws securing
the radio. Unplug and remove radio.
(Figure B)
3
Continue to kit assembly.

2
99-7330 KIT ASSEMBLY
B
A
RECESSED DIN MOUNT RADIO
PROVISION WITH POCKET
Slide the aftermarket radio into the
DIN cage/housing assembly until it
snaps into place.
(Figure B)
2
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs outward. (Figure A)
1

3
99-7330 KIT ASSEMBLY
B
A
ISO MOUNT RADIO PROVISION WITH POCKET
Slide the radio/bracket assembly into
the radio housing until the assembly
snaps into place.
(Figure B)
2
Snap the ISO trim plate onto the radio
and housing assembly.
(Figure B)
3
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
Align the holes from the ISO snap in
brackets with the holes in the side of
the radio and mount the brackets to
the radio using screws supplied with
the radio.
(Figure A)
1