Metra Electronics 95-7324 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-7324
95-7324
APPLICATIONS
KIA Optima
2006.5-2010
KIT FEATURES
•Double DIN radio provision
•Stacked ISO units provision
A) Double DIN Trim Plate • B) Double DIN Brackets
KIT COMPONENTS
AB
TOOLS REQUIRED:
Phillips Screwdriver • Small Flat Blade Screwdriver/ Panel Removal Tool
1-800-221-0932
©COPYRIGHT 2004-10 METRA ELECTRONICS CORPORATION
www.metraonline.com
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
•70-1004 - Hyundai 2006-up/KIA harness 2004-up
•70-7303 - Hyundai / KIA Harness 2009
Antenna Adapter:
•40-KI11 - 2009-10 Kia Optima

Dash Disassembly
-Kia Optima 2006.5 - 2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . 1
Kit Assembly *
-Double DIN Radio Provision. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
-Stacked ISO Units Provision. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Final Assembly ...........................................4
TABLE OF CONTENTS
95-7324
*Note:
Refer also to the instructions included with the aftermarket radio.

95-7324 DASH DISASSEMBLY
KIA OPTIMA 2006.5-2010
PUSH
A/CPUSH
TEMP
FM
AM
4RPT
POWER
VOLUME
SEEK
TRACK
103.9
123
2
FF
REW
5
RDM
A
103.5 FM
3:05
EQ
CD
FM
AM SCAN
AUDIO
POWER
VOLUME TUNE
SEEK
TRACK RPT
RDM FF
REW
1
4
2
5
3
6
B
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the panel sur-
rounding the radio including the a/c
vents and climate controls. (Figure A)
2
Remove (4) Phillips screws securing
radio. Unplug and remove radio.
(Figure B)
3
Continue to kit assembly.

95-7324 KIT ASSEMBLY
2
A
B
DOUBLE DIN RADIO PROVISION
Snap the Double DIN brackets to
the inside edge of the Double DIN
trim plate.
(Figure A)
1
Slide the Double DIN radio into the
bracket/trim plate assembly and
secure the radio to the assembly
using the screws supplied with the
radio.
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.

95-7324 KIT ASSEMBLY
3
A
B
STACKED ISO UNITS PROVISION
Snap the Double DIN brackets to
the inside edge of the Double DIN
trim plate. (Figure A)
1
Slide the stacked ISO units into the
bracket/radio housing assembly
and secure the units to the kit
using the screws supplied with the
units.
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.

95-7324 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
1
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown belowand the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground..................Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer.................Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4

95-7324
NOTES
5

95-7324 INSTRUCTIONS
1-800-221-0932
REV. 04/27/10 © COPYRIGHT 2004-10 METRA ELECTRONICS CORPORATION INST95-7324
www.metraonline.com