Metra Electronics 95-5818 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-5818
95-5818
KIT FEATURES
• A) & B) (2) Double Din Trim Plates • C) Double Din Brackets
KIT COMPONENTS
TOOLS REQUIRED:
Dremel or Suitable Cutting Tool • Small Flat Blade Screwdriver
•Panel Removal Tool • Socket Wrench
• Metra 86-5618 Removal Keys
1-800-221-0932
©COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION
www.metraonline.com
A
APPLICATIONS
FORD
F-150 2004 Heritage / F-150 1997-2003
Expedition 1997-2002
F650 2005-2008
LINCOLN
Navigator 1997-2002/Blackwood 2001-2003
•Double DIN Head Unit Provision
•Stacked ISO Mounts Units Provision
NOTE: Major sub dash modifications
arenecessaryto use this dash kit. You
will need to trim the sub dash to gain
suitable depth and height.
C
B
WIRING AND ANTENNA CONNECTIONS
(Sold Separately)
Wiring Harness:
•See www.metraonline.com for specific interface
Antenna Adapter:
•Not required

Dash Disassembly
-150 2004 Heritage / F-150 1997-2003 / Expedition 1997-2002 /
F650 2005-2008 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Lincoln
-Lincoln Navigator 1997-2002 / Blackwood 2001-2003 . . . . . . . . . . . . . .1
Kit Assembly
-Double DIN/Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . 2
TABLE OF CONTENTS
95-5818
*Note:
Refer also to the instructions included with the aftermarket radio.
K NOWLEDGE IS P OWER
Enhanceyour installation and fabrication skillsby
enrolling in the most recognizedandrespected
mobile electronics school in our industry.
Log onto www.installerinstitute.comor call
800-354-6782 for more informationandtake steps
toward abetter tomorrow.

95-5818 DASH DISASSEMBLY
A
B
C
CUT OUT
TOP
CUT BAR CUT BAR
D
1
1
Using the Metra 86-5618 removal
keys, slide the radio out of the radio
cavity.Unplug and remove the radio.
(
Figure B)
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
3
Unclip and remove the panel sur-
rounding the radio. ( Figure A)
2
Remove the (4) 7 MM screws at the
sides of the factoryclimate control
and remove the factory climate con-
trol. (
Figure C)
4
Cut and remove obstructions in dash
cavity. (Be careful not to cut into har-
nesses or electronic components)
(
Figure D)
5
Continue to kit assembly.
FORD F-150 2004 HERITAGE/F-150 1997-2003
EXPEDITION 1997-2002/
F650 2005-2008/
LINCOLN NAVIGATOR 1997-2002/BLACKWOOD 2001-2003

95-5818 KIT/FINAL ASSEMBLY
2
DOUBLE DIN/STACKED ISO MOUNT
UNIT(S) PROVISION
Attach the double DIN brackets to
the double DIN or stacked ISO Mount
unit(s) using the screws supplied
with the unit(s).
(Figure A)
1
*Note: Refer also to the instructions included with the aftermarket radio.
A
NOTE: Major sub dash modifications arenecessaryto use this dash kit. You will
need to trim the sub dash to gain suitable depth and height.
B
A
B
C
D
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter and mak-
ing the connections as shown.
(Isolate and individually tape off the
ends of any unused wires to prevent
electrical short circuit).
(Figure B)
Re-connect the negative batteryter-
minal and test the unit for proper
operation.
2
3
Continued on page 3.

95-5818 KIT/FINAL ASSEMBLY
FINAL ASSEMBLY
Reassemble the rest of the dash in
reverse order of disassembly.
Makewiring connections using the EIA color code chart shown belowand the instructions
included with the head unit. Metra recommends making connections shown below; Strip, Splice,
Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short
circuit.
6
3
FINAL WIRING CONNECTIONS
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna............Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer.................Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE:
When a Blackwireis not present, ground radio to vehicle chassis. All colors may not be
present on all leads due to manufacturer’sspecifications.
Enjoy your newly installed radio!
NOTE: Major sub dash modifications arenecessaryto use this dash kit. You will
need to trim the sub dash to gain suitable depth and height.
Slide the double DIN radio or stacked
ISO Mount unit assembly into the mod-
ified sub dash until it clicks into place.
4
Attach the appropriate double DIN trim
plate using the top 2 screw positions
of the climate control. (Figure C)
5
C
Continued from page 2.

NOTES
4
95-5818

NOTES
5
95-5818

95-5818 INSTRUCTIONS
1-800-221-0932
REV.06/08/10 © COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION INST95-5818
www.metraonline.com