Metra Electronics 99-7326 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-7326
99-7326
KIT FEATURES
•DIN Radio Provision with Pocket
•ISO Radio Provision with Pocket
A) Radio Housing B) ISO Brackets C) Trim Plate
KIT COMPONENTS
A
Small Flat Blade Screwdriver/ Panel Removal Tool
•Phillips Screwdriver
1-800-221-0932
©COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
www.metraonline.com
APPLICATIONS
Hyundai Elantra 2007-2010
(US Model Only)
(Non Radio Delete)
(Non Touring Model)
BC
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
•70-1004 - Hyundai 2006-up /KIA harness 2004-up
•70-7303 - Hyundai/KIA harness 2009
Antenna Adapter:
•40-KI11 - KIA antenna adapter 2007-up
TOOLS REQUIRED:

Dash Disassembly
-HyundaiElantra2007-2010........................................1
Kit Assembly
-DINRadioProvisionwithPocket ..................................2
-ISORadioProvisionwithPocket...................................3
Final Assembly ..........................................4
TABLE OF CONTENTS
99-7326
*Note:
Refer also to the instructions included with the aftermarket radio.

99-7326 DASH DISASSEMBLY
HYUNDAI ELANTRA 2007-2010
A
B
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Unclip and remove the panel sur-
rounding the radio including the a/c
vents and hazard button. (Figure A)
2
Remove (4) Phillips screws to remove
radio.
3
Continue to kit assembly.
1
2
3
4
A/C

2
99-7326 KIT ASSEMBLY
B
A
DIN RADIO PROVISION WITH POCKET
Slide the aftermarket radio into the
cage until it snaps into place.
(Figure B)
2
Snap the trim plate into the Radio
Housing.
(Figure B)
3
Note: The trim plate supplied with the
99-7326 is required for a complete
installation. ISO mounting may be pre-
ferrred as it is easier than DIN mount-
ing and using this trim plate.
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs outward. (Figure A)
1

3
99-7326 KIT ASSEMBLY
B
A
ISO RADIO PROVISION WITH POCKET
Slide the radio into the radio opening
until the side clips snap into place.
(Figure B)
2
Snap the trim plate onto the front of
the Radio Housing. (Figure B)
3
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
Mount the ISO Brackets to the after-
market radio using the screws sup-
plied with the radio. (Figure A)
1