Metra Electronics 95-6545B User manual

CAUTION! All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 1/17/18 INST95-6545B
INSTALLATION INSTRUCTIONS
95-6545B
KIT FEATURES
• ISO DDIN radio provision
• Painted matte black
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) (7) Panel clips
A B C
Jeep Compass 2017.5-up*
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
WIRING & ANTENNA CONNECTIONS (sold separately)
Wire harness: • XSVI-6523-NAV
Antenna adapter: • 40-EU10
Steering wheel control interface: ASWC-1
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3

2
DASH DISASSEMBLY
1. Unclip and remove the a/c vent panel
surrounding the radio.
2. Remove (4) 9/32” screws securing the
radio, then unplug and remove the radio.
Continue to Kit Preparation
KIT PREPARATION
(Figure A)
1. Attach the (7) panel clips to the radio
trim panel . (Figure A)
Continue to Kit Assembly

REV. 1/17/2018 INST95-6545B 3
(Figure A)
KIT ASSEMBLY
ISO DDIN radio provision
1. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or Axxess.
3. Test the radio for proper operation.
4. Secure the radio assembly to the dash
using the factory screws.
5. Snap the radio trim panel over the radio
assembly to complete the installation.
Discover other car stereo video installation parts on our website.