Metra Electronics 95-3105 User manual

INSTALLATION INSTRUCTIONS FOR PART 95-3105
KIT FEATURES
• DDIN Head Unit Provision
• ISO Stacked Head Unit Provision
A) DDIN Brackets B) DDIN Trim Plate
KIT COMPONENTS
TOOLS REQUIRED:
95-3105
A
APPLICATIONS
SATURN
1995-99 ALL MODELS
B
• Phillips Screwdriver • Panel Removal Tool • Socket Wrench
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
HARNESS:
ANTENNA ADAPTER:
• 70-1858 - GM Harness 1988-2005
• 40-GM10 - GM Antenna Adapter 1998-up

95-3105 DASH DISASSEMBLY
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
Remove (2) pop-clips from the sides
of the radio trim bezel. (Figure A)
2
SATURN (ALL MODELS) 1995-99
Unclip the radio trim bezel, discon-
nect the switch wiring and remove
the bezel. (Figure A)
3
Remove (2) 7mm hex-head screws
securing the top of the factory head
unit and disconnect the wiring.
(Figure B)
4
A
B

Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the unit for proper operation.
1
A
Attach the Double DIN brackets to
the Double DIN trim plate. (Figure A)
2
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly and
secure the Double DIN head unit or
stacked ISO head units to the
assembly using the screws supplied
with the radio. (Figure B)
3
Reassemble dash in reverse order of
disassembly.
4
DOUBLE DIN / STACKED ISO DIN
HEAD UNIT PROVISION
B
95-3105
KIT ASSEMBLY
METRA ACCESSORIES STEREO DASH KITS