Metra Electronics KIT FEATURES 99-9123 User manual

KIT COMPONENTS
KIT FEATURES
Shaft unit
provisions
Faceplate
TOOLS REQUIRED
Cutting tool
Adjustable wrench
Flat-blade screwdriver
Snap-in Bracket
99-9123
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
VOLKSWAGEN
Jetta 1994-00..........................................................1-2
Passat 1998-00.........................................................1-2
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 230701

12
Attach the Faceplate to the Snap-in Bracket.
Slide the aftermarket head unit into the kit and
secure with shaft nuts.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the
factory radio knobs and shaft nuts. Unclip the factory faceplate. Insert a flat-blade screwdriver
into the shaft wells and push in on the side springs. Pull the factory radio out and disconnect
the wiring.
Slide the aftermarket head unit into the Snap-in Bracket. If the shafts of the head unit do not
pass easily through the kit, cut and remove the upper-shaft tabs from the shaft openings.("A")
3 4
1
2
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
5
Re-connect the battery terminal and test the unit for proper operation. Snap the head unit/kit
assembly into the sub-dash.
"A"
ALL VEHICLES